2003 Oct 21 26
Philips Semiconductors Product specification
Car radio integrated signal processor TEF6894H
11.1.3 DATA BYTE 3; USN AND WAM
Table 9 Format of data byte 3
Table 10 Description of data byte 3
11.2 Write mode
Table 11 Format for subaddress byte with default setting
Table 12 Description of subaddress byte
Table 13 Selection of data byte
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
USN3 USN2 USN1 USN0 WAM3 WAM2 WAM1 WAM0
BIT SYMBOL DESCRIPTION
7 to 4 USN[3:0] Ultrasonic noise detector. USN content of the MPXRDS audio signal; see Fig.5.
3 to 0 WAM[3:0] Wideband AM detector. WAM content of the LEVEL voltage; see Fig.6.
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
AIOF GATE SGAT SA4 SA3 SA2 SA1 SA0
− 00−−−−−
BIT SYMBOL DESCRIPTION
7 AIOF Auto-increment off. 0 = auto-increment enabled; 1 = auto-increment disabled.
6GATEGate. 0=I
2
C-bus outputs (SDAG and SCLG) are controllable by the shortgate or the
autogate function; 1 = I
2
C-bus outputs are enabled.
5 SGAT Shortgate. 1=I
2
C-bus outputs (SDAG and SCLG) are enabled for a single
transmission following this control and disabled automatically.
4 to 0 SA[4:0] Data byte select. The subaddress value is auto-incremented when AIOF = 0 and will
revert from SA = 30 to SA = 0. SA = 31 can only be accessed via direct subaddress
selection, in which case auto-increment will revert from SA = 31 to SA = 0; see
Table 13.
SA4 SA3 SA2 SA1 SA0 HEX
(1)
MNEMONIC ADDRESSED DATA BYTE
000102RDSCLK test control
001004CONTROL control of supply and AF update
001015CSALIGN alignment of stereo channel separation
001106MULTIPATHcontrol of weak signal sensitivity and
timing
001117SNC alignment of SNC start and slope
010008HIGHCUT alignment of HCC start and slope
010019SOFTMUTE alignment soft mute start and slope
01010ARADIO control of radio functions
01011BINPUT/ASI input selector and ASI settings
01100CLOUDNESS loudness control
01101DVOLUME volume control