SpecNo.JELF243C-0007P-01
P.8/9
MURATA MFG. CO.,LTD.
Reference
Only
11.7 Cleaning Conditions
Products shall be cleaned on the following conditions.
(1) Cleaning temperature shall be limited to 60°C max.(40°C max for IPA)
(2) Ultrasonic cleaning shall comply with the following conditions with avoiding the resonance
phenomenon at the mounted products and P.C.B.
Power : 20 W / l max. Frequency : 28kHz to 40kHz Time : 5 min max.
(3) Cleaner
1. Alcohol type cleaner
Isopropyl alcohol (IPA)
2. Aqueous agent
PINE ALPHA ST-100S
(4) There shall be no residual flux and residual cleaner after cleaning.
In the case of using aqueous agent, products shall be dried completely after rinse with de-ionized
water in order to remove the cleaner.
(5) Other cleaning Please contact us.
11.8 Resin coating
Inductance value may be changed due to the large cure-stress of the resin when products are coated
with resin. In this case, take care when you select resin to prevent the deterioration of the product quality.
11.9 Caution for use
The pattern of the chip coil is covered with the protection film. But the handing the chip coil shall be taken
care so that the chip coil would not be damaged with the pick-up nozzle, the sharp substance and so on.
11.10 Handling of a substrate
After mounting products on a substrate, do not apply any stress to the product caused by bending or
twisting to the substrate when cropping the substrate, inserting and removing a connector from the
substrate or tightening screw to the substrate.
Excessive mechanical stress may cause cracking in the product.
Bending Twisting
11.11 Storage and Handing Requirements
(1) Storage period
Use the products within 12 months after delivered.Solderability should be checked if this period is exceeded.
(2) Storage conditions
・Products should be stored in the warehouse on the following conditions.
Temperature : -10°C ~ 40°C
Humidity : 15% to 85% relative humidity No rapid change on temperature and humidity.
・Products should not be stored on bulk packaging condition to prevent the chipping of the
core and the breaking of winding wire caused by the collision between the products.
・Products should be stored on the palette for the prevention of the influence from humidity,
dust and so on.
・Products should be stored in the warehouse without heat shock, vibration, direct sunlight and
so on.
(3) Handling Condition
Care should be taken when transporting or handling product to avoid excessive vibration or
mechanical shock.
12. △
!
Notes
(1)Please make sure that your product has been evaluated in view of your specifications with our product being
mounted to your product.
(2)You are requested not to use our product deviating from the reference specifications.
(3)The contents of this reference specification are subject to change without advance notice.
Please approve our product specifications or transact the approval sheet for product specifications
before ordering.