Home»Store»Programmers»Mach X Programmer
SEARCH
Home
Our Company
Compiler
Hardware
Support
Products
Contact
Mach X Pro
ramme
Click to enlarge
Mach X
Programmer/
Debugger
$199.00
Tag Connect
$29.95
TRANSLATE | LOG IN | CART CONTENTS (1)
The Mach X Programmer is a full-featured device programmer that programs a wide range of
parts including chips with flash memory and One-Time-Programmable devices (OTP's). High
speed programming is accomplished by an internal PIC18 MCU running at 40MHz.
Mach X features:
z
Supports: PIC10, PIC12, PIC14, PIC16, PIC18, PIC24, dsPIC
®
, MCPxxxx(CAN Bus
chips) Click here to view a detailed list of supported devices for the Mach X
Programmer.
z Program various DIP chips (8-40 pins) via a unified 40-pin ZIF socket on the unit. The
advanced ICSP signal routing logic allows programming chips with various DIP pin-
outs (8-40 pins) via a single 40-pin ZIF socket.
z Supports In-Circuit programming via a standard ICD connector. The device can also
be used as an ICD debugger with CCS Windows IDE compilers through a USB
interface.
z No additional power supply is required as the unit is powered from the USB bus.
z Drivers and software are available for Linux and Windows (32 or 64-bit). Mach X
firmware updates are handled by the software over the USB bus.
z Can program and read standard HEX and COF files. Devices can be read to generate a
hex file or disassembly .ASM file. Burn parameters are saved in the hex file as
comments. It also supports grouping hex files so multiple hex files can be merged into
the same part.
z User selectable verify voltages (2V to 5.5V). This fulfills all requirements on a
production programmer required by Microchip's ICSP specifications.
z The Start/Repeat pushbutton, in conjunction with our device programming software,
provides a simple and efficient way of batch programming.
z The software provides an advanced and efficient way of serial numbering when
programming a batch of parts. It handles serial numbering in binary or ASCII mode.
Serial numbers can be supplied from an external file, from a list file, or via a user
prompt.
z Calculates and programs calibration constants for parts with an internal oscillator.
For a comparison to other Programmers please visit www.mcuspace.com
Learn more about Tag Connect and how this production
Page 1 of 2CCS, Inc. - Mach X Programme
9/24/2009htt
://www.ccsinfo.com/
roduct
info.
h
?cPath=Store
Software&
roducts
id=machx
