MINI-PS- 12- 24DC/48DC/0.7
104349_en_00 PHOENIX CONTACT 9
11 Output
OUT DC
DC
OK
DC
OK
VDC
-
-
--
+
+
IN DC
+
+
NC
NC
The connection is established via screw connection terminal
blocks "+" and "-" of the DC output. The output voltage can be
adjusted on the potentiometer from 30 V DC ... 56 V DC.
Protection of the secondary side
The device is electronically protected against short circuit and
idling. In the event of a malfunction, the output voltage is
limited to 60 V DC. Make sure that all output lines are
dimensioned according to the maximum output current or are
separately protected! The cables on the secondary side
should have large cross sections in order to keep the voltage
drops on the lines to a minimum.
ATTENTION: Module can become
damaged
Make sure that all output lines are dimensioned
according to the maximum output current or are
separately protected. The cables on the
secondary side must have sufficiently large
cross sections in order to keep the voltage
drops on the lines as low as possible.
12 Signaling
For function monitoring, there is the active DC OK switching output and the DC OK LED.
State 1 State 2
"DC OK" LED ON OFF
Active DC OK switching
output
U
OUT
(with reference to "–") U = 0 V (in reference to "–")
Meaning Normal operation of the power supply unit.
U
OUT
> 0.9 x UN
U
OUT
≤ 0.9 x UN
Secondary load short-circuit or overload
No mains voltage or device defective
