SPEC NO: DSAO4028 REV NO: V.5B DATE: NOV/19/2016 PAGE: 2 OF 6
APPROVED: Wynec CHECKED: Allen Liu DRAWN: L.T.Zhang ERP: 1203015039
Selection Guide
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity / luminous Flux: +/-15%.
3. Luminous intensity value is traceable to CIE127-2007 standards.
Absolute Maximum Ratings at TA=25°C
Electrical / Optical Characteristics at TA=25°C
Notes:
1. Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to CIE127-2007 standards.
4. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Part No. Emitting Color (Material) Lens Type
Iv (mcd) [2]
@ 5mA
iewing
Angle [1]
2θ1/2
Min. Typ.
APGF1011SEEPBVGC-TT
Green (InGaN)
Water Clear
50 80
Blue (InGaN) 10 23
Hyper-Red (AlGaInP) 15 30
150
°
Symbol Parameter Emitting Color Typ. Max. Units Test Conditions
λpeak Peak Wavelength
Green
Blue
Hyper-Red
518
461
632
nm I
F=5mA
λD [1] Dominant Wavelength
Green
Blue
Hyper-Red
527
467
624
nm I
F=5mA
Δλ1/2 Spectral Line Half-width
Green
Blue
Hyper-Red
35
22
20
nm I
F=5mA
C Capacitance
Green
Blue
Hyper-Red
100
110
25
pF V
F=0V;f=1MHz
V
F [2] Forward Voltage
Green
Blue
Hyper-Red
3
2.9
1.95
3.2
3.1
2.3
V IF=5mA
I
R Reverse Current
Green
Blue
Hyper-Red
50
50
10
uA VR=5V
Parameter Green Blue Hyper-Red Units
Power dissipation [1] mW
DC Forward Current [2] 10 10 10 mA
Peak Forward Current [3] 50 50 50 mA
Reverse Voltage 5 V
Operating Temperature -40°C To +85°C
Storage Temperature -40°C To +100°C
35
Electrostatic Discharge Threshold (HBM)
1000 1000 3000 V
Notes:
1. Within 35mW when multiple chips are lightened
2. The maximum ratings are valid for the case of lighting a single chip
When two chips are lit at the same time, each chip should be driven at a current lower than 50% of the absolute maximum ratings
When three chips are lit at the same time, each chip should be driven at a current lower than 30% of the absolute maximum ratings
3. Duty Cycle 1/20, Pulse Width=1ms.
4. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static
electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033.
