Reference only
ESRH04
9 / 13
No.
AEC-Q200
Test Item
Specifications AEC-Q200 Test Method
17 Electrical
Characte-
rization
Apperance No defects or abnormalities Visual inspection.
Capacitance Within the specified tolerance The capacitance, Q should be measured at 25C at the frequency
and voltage shown in the table.
Nominal Cap. Frequency Voltage
C 1000pF 10.1MHz AC0.5 to 5V(r.m.s.)
C > 1000pF 10.1kHz AC10 . 2 V ( r.m.s.)
Q Q 1,000
Insulation
Resistance
(I.R.)
Room
Temperature
10,000M min.
The insulation resistance should be measured at 253 C with a
DC voltage not exceeding the rated voltage at normal temperature
and humidity and within 2 min. of charging.
(Charge/Discharge current 50mA)
High
Temperature
20M min. The insulation resistance should be measured at 2005 C with a
DC voltage not exceeding 25% of the rated voltage at normal
temperature and humidity and within 2 min. of charging.
(Charge/Discharge current 50mA)
Dielectric
Strength
Between
Terminals
No defects or abnormalities The capacitor should not be damaged when voltage in Table is
applied between the terminations for 1 to 5 seconds.
(Charge/Discharge current 50mA.)
Rated voltage Test voltage
DC200V 250% of the rated voltage
DC500V 150% of the rated voltage
Body
Insulation
No defects or abnormalities The capacitor is placed in a container with
metal balls of 1mm diameter so that each
terminal, short-circuit, is kept approximately
2mm from the balls as shown in the figure,
and voltage in table is impressed for 1 to 5
seconds between capacitor terminals and
metal balls.
(Charge/Discharge current 50mA.)
Rated voltage Test voltage
DC200V 250% of the rated voltage
DC500V 150% of the rated voltage
18 Terminal
Strength
Tensile
Strength
Termination not to be broken or loosened As in the figure, fix the capacitor body, apply the force gradually
to each lead in the radial direction of the capacitor until reaching
10N and then keep the force applied for 101 seconds.
Bending
Strength
Termination not to be broken or loosened Each lead wire should be subjected to a force of 2.5N and then
be bent 90° at the point of egress in one direction. Each wire is
then returned to the original position and bent 90° in the opposite
direction at the rate of one bend per 2 to 3 seconds.
19 Capacitance
Temperature
Characteristics
Within the specified Tolerance.
-750+120/-347ppm/C (-55～25C)
-750±120ppm/C
(25～125C)
-750+347/-120ppm/C (125～200C)
The capacitance change should be measured after 5min. at
each specified temperature step.
The temperature coefficient is determind using the capacitance
measured in step 3 as a reference. When cycling the temperature
sequentially from step 1 through 5 (-55C to +150C)
the capacitance should be within the specified tolerance for the
temperature coefficient and capacitance change as Table A.
The capacitance drift is caluculated by dividing the differences
betweeen the maximum and minimum measured values in the
step 1, 3 and 5 by the capacitance value in step 3.
* “room condition” Temperature:15 to 35°C, Relative humidity:45 to 75%, Atmosphere pressure:86 to 106kPa
Step Temperature(C)
1 252
2 -553
3 252
4 2005
5 252
F
Approx.
2mm
Metal
balls
