Technical data
Type Order No.
Pcs
.
Pkt.
Panel feed-through
,
for external wall mounting, with manual solder/tab connection
4.8 x 0.8 mm, 4-position, metric thread
Q 1,5/4FL/24-M20KU-ESA 16 41 47 1 10
Panel feed-through
,
with core output 1.5 mm
2
and 0.5 m stranded wire
4-position, metric thread
Q 1,5/4A50/24-M20KU-ESA 16 41 64 6 10
Nut,
(plastic)
to lock the contact carrier from the inside of the device
M 20 / WAF 26
Q-MU M 20 16 40 70 2 25
Allen wrench,
to loosen or tighten the QUICKON union nut
wrench size 19
QSS 19 16 70 89 5 1
Diagonal cutter,
for Cu wire up to 1.5 mm ø
MICROFOX SC 12 05 86 2 1
Closing cap,
for closing unoccupied connections
QPROT 13/16 16 70 22 2 10
Insulating sleeve,
as shock protection
for 4.8 mm tab receptacles; first slide over the conductor
PT/FS 4,8 16 70 49 7 25
General characteristics
Number of positions
Wrench size of the union nut [mm]
Torque of the union nut [Nm]
Wrench size of the contact carrier [mm]
Tightening torque of the contact carrier [Nm]
Tightening torque of the counter nut [Nm]
Conductor data for the QUICKON connection
Cross section range of the cores [mm
2
] / AWG
Structure of individual litz wire/smallest wire diameter [mm]
Core insulation material
External cable diameter [mm]
Core diameter (including insulation) [mm]
Environmental conditions
Protection type (IEC 60 529/EN 60 529/DIN VDE 0470-1)
Ambient temperature/temperat. when conductor is connected [°C]
Electrical characteristics
Nominal current (Ambient temperature: 40 °C) [A]
Rated voltage [V AC]
Surge voltage category/contamination class
Mechanical characteristics
Frequency of the connect. of conductors of the same cross section
Impact category
Material data
Contact material / Contact surface
Insulation material / Inflammability class in acc. with UL 94
Approval
4
19
3
24
4.5
4.5
0.75 - 1.5 / 18 - 16
VDE 0295 class 2 to 5 / 0.2
PVC / PE / Rubber
3
)
6 - 12
≤
3
IP 65 / IP 67
- 25 to + 80 / - 5 to + 50
1
)
17.5
500
2
)
III/3
10
4
Cu alloy / pre-nickel plated and tin-plated
PA / V0
VDE-, UL-, CSA approval applied for
1
) Specifications of the cable manufacturer must also be observed.
2
) With insulating sleeve PT/FS 4,8. Without insulating sleeve 250 V AC.
3
) Requirements for rubber are available on request.
Note:
– For permanent installation.
– QUICKON components may only be operated when under
no load.
QUICKON-ONE Panel Feed-Through
Phoenix Contact page 2 of 3
