Evaluation Board User Guide UG-055
Rev. A | Page 3 of 12
EVALUATION BOARD HARDWARE
EVALUATION BOARD CONFIGURATIONS
The ADP122/ADP123 evaluation boards are supplied with
different components, depending on the version that is ordered.
Components common to both versions are C1, C2, TP1, TP2, and
J1. Figure 3 and Figure 4 show the schematics of the ADP122
and ADP123 evaluation board configurations. Table 1 describes
the components.
1
2
3
5
4
08524-003
C2
TP1 TP2
C1
J1
V
OUT
V
IN
VOUT
NC
VIN
GND
EN
U1
Figure 3. ADP122 Evaluation Board Schematic
1
2
3
5
4
08524-004
C2
R1
R2
TP1 TP2
TP3
C1
J1
V
OUT
IN
VOUT
ADJ
VIN
GND
EN
U1
Figure 4. ADP123 Evaluation Board Schematic
Table 1. Evaluation Board Hardware Components
Component Description
U1
1
ADP122/ADP123 low dropout linear regulators
C1 Input bypass capacitor, 1 μF, 0603 size
C2 Output capacitor, 1 μF, 0603 size
J1
Jumper (connects EN to VIN for automatic
startup)
TP1 Test point closer to VIN
TP2 Test point closer to VOUT
TP3
Test point closer to ADJ (ADP123 evaluation
board only)
R1, R2
0603 size feedback resistors between VOUT and
ADJ (ADP123 evaluation board only)
1
Component depends on evaluation board type ordered.