LC717A10ARGPGEVB
http://onsemi.com
4
Table 3. JUMPER, PATTERN FOR ADDITIONAL PARTS
Pattern Parameter Set Contents
C2 Pattern for Cref Capacity Adjustment Implement capacitor of any capacity as needed. (Size: 1608)
C3 Pattern for CrefAdd Capacity
Adjustment
Implement capacitor of any capacity as needed. (Size: 1608)
R3 Pattern for SCL Pull-up
When I
2
C compatible bus is chosen by nCS, implement a resistance of 2.2 kW.
(Size: 1608) (Pull-up VDD)
R4 Pattern for SDA Pull-up
When I
2
C compatible bus is chosen by nCS, implement a resistance of 2.2 kW.
(Size: 1608) (Pull-up VDD)
R5 Pattern for nCS Pull-up
When I
2
C compatible bus is chosen by nCS, implement a resistance of 2.2 kW.
(Size: 1608) (Pull-up VDD)
R7 Reserve Pattern (R7 Initialization: Short) (Size: 1608)
R8 Reserve Pattern (R8 Initialization: Open) (Size: 1608)
JP1 Pattern for I
2
C Compatible Bus Slave
Address Selection
When I
2
C compatible bus is chosen by nCS, set the I
2
C compatible bus slave
address by JP1 and JP2. When SPI is chosen, connect to the ground.
(JP1 Initialization: Ground Short)
1−2 Short: H Level
2−3 Short: L Level
JP2 Pattern for I
2
C Compatible Bus Slave
Address Selection/SO Pull-down
When I
2
C compatible bus is chosen by nCS, set the I
2
C compatible bus slave
address by JP1 and JP2. When SPI is chosen, implement a resistance of 100 kW
between 2 to 3. (It has been implemented.) (JP2 Initialization: Ground Pull-down)
1−2 Short: H Level
2−3 Short: L Level
Table 4. LC717A10AR I
2
C COMPATIBLE BUS SLAVE ADDRESS
SA1 Input
(JP1)
SA0 Input
(JP2)
7bit Slave Address Binary Notation 8bit Slave Address
Low Low 0x16
00101100b (Write) 0x2C
00101101b (Read) 0x2D
Low High 0x17
00101110b (Write) 0x2E
00101111b (Read) 0x2F
High Low 0x18
00110000b (Write) 0x30
00110001b (Read) 0x31
High High 0x19
00110010b (Write) 0x32
00110011b (Read) 0x33
HOW TO USE
1. Connection of connector pin.
Solder attached connector pin (8pin) at the
position pictured in Figure 3.
2. Connect the LC717A10ARGPEVB to a board
with a designed switch pattern. When designing
a switch pattern, please refer to the Application
and Design Note on the ON Semiconductor Touch
Sensor Homepage.
3. Connect LC717A10ARGPGEVB to PC through
an USB-to-Serial conversion module. Supply the
power, and verify the Power LED is turned on.
4. Install evaluation software to PC. The evaluation
software is available from the ON Semiconductor
Homepage, and selecting “LC717A10 software”.
Double-click on the icon “LC717A10App.exe”
from the installed folder and start it.
5. Press RESET Switch when evaluation board is
acting strange.
6. Please note: If the user directly touches the LSI on
the evaluation board or patterns with their finger, it
may cause malfunction or breakdown.
