PI49FCT32807
3.3V 1:10 CMOS Clock Driver
2
PS8496B 11/13/08
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the
device. This is a stress rating only and functional op er a tion
of the device at these or any other con di tions above those
indicated in the operational sec tions of this spec i fi ca tion is
not implied. Ex po sure to ab so lute maximum rating condi-
tions for extended pe ri ods may affect re li abil i ty.
DC Electrical Characteristics (Over the Operating Range)
Symbol Parameter Test Condition
(1)
Min. Typ. Max. Units
V
OH
Output High Voltage V
CC
= 3V, V
IN
= V
IH
or V
IL
I
OH
= -8mA 2.4 3.0
V
V
OL
Output Low Voltage V
CC
= 3V V
IH
or V
IL
I
OL
= 12mA 0.4 0.5
V
IH
Input High Voltage Guaranteed Logic HIGH Level (Input pins) 2.0 505
V
IL
Input Low Voltage Guaranteed Logic LOW Level (Input pins) -0.5 0.8
I
IH
Input High Current V
CC
= 3.6V V
IN
= 3.6V 1
μA
I
IL
Input Low Current V
CC
= 3.6V V
IN
= 0V -1
V
IK
Clamp Diode Voltage V
CC
= Min., I
IN
= -18mA -0.7 -1.2 V
I
OH
Output HIGH Current V
CC
= 3.3V, V
IN
=V
IL
or V
IH,
V
OUT
= 1.5V
(5)
-25 -45 -80
mAI
OL
Output LOW
Current V
CC
= 3.3V, V
IN
=V
IL
or V
IH,
V
OUT
= 1.5V
(5)
25 45 90
I
OS
Short Circuit
(5)
Current V
CC
= Max., V
OUT
= GND
(5)
-50 -100 -180
V
H
Input Hysteresis 150 mV
R
S
Internal Series Resistor 22 Ω
Storage Temperature ............................................................ –65°C to +150°C
Ambient Temperature with Power Applied ........................... –40°C to +85°C
Supply Voltage to Ground Potential (Inputs & V
CC
Only) ..... –0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) .. –0.5V to +7.0V
DC Input Voltage ....................................................................–0.5V to +7.0V
DC Output Current ............................................................................... 120mA
Power Dissipation ................................................................................... 0.5W
Notes:
1. For Max. or Min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device type.
2. Typical values are at V
CC
= 3.3V, +25°C ambient and maximum loading.
3. V
OH
= V
CC
– 0.6V at rated current.
4. This parameter is determined by device characterization but is not production tested.
5. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
