Vibration
Mounting: Vibration capability is dependent upon mounting restraint.
All Sizes = 10g
Vibration Test Level
The specimens, while deenergized or operating under the load conditions
specied, shall be subjected to the vibration amplitude, frequency range,
and duration specied for each case size.
Amplitude
The specimens shall be subjected to a simple harmonic motion having an
amplitude of either 0.06-inch double amplitude (maximum total excursion)
or peak level specied above, whichever is less. The tolerance on vibration
amplitude shall be ±10 percent.
Frequency Range
The vibration frequency shall be varied logarithmically between the
approximate limits of 10 to 2,000 Hz.
Sweep Time and Duration
The entire frequency range of 10 to 2,000 Hz and return to 10 Hz shall be
traversed in 20 minutes. This cycle shall be performed 12 times in each
of three mutually perpendicular directions (total of 36 times), so that
the motion shall be applied for a total period of approximately 12 hours.
Interruptions are permitted provided the requirements for rate of change
and test duration are met.
Thermal Resistance
Thermal Resistance (°C/W) by Case Length
# of Sides
heatsinked
Insulation 36.4 (mm) 45.9 (mm) 53.8 (mm) 66.5 (mm)
One Side
Bare can 6.60 5.20 4.44 3.60
Polyester 7.78 6.13 5.24 4.24
Both Sides
Bare can 4.95 3.87 3.30 2.66
Polyester 5.54 4.34 3.70 2.98
Typical Weight Case AA - 19g, Case AB - 22g, Case AC - 26g, Case AD - 34g
Terminals 20 AWG copper wire with tin electroplate, 15 amps max
Case Material Aluminum with a Stainless Steel Sleeve
Ripple Current Capability The max ripple current capability is set by the target core temperature of
105 ºC. The Peak to Peak ac must be less than Vr/5 max.
Air Cooled The ripple currents in the ratings tables are for 85 ºC ambient temperatures.
Heatsink Cooled Temperature rise from the hottest internal spot, the core, to ambient air is
∆T = I
2
(Max ESR)(θcc + θca), recommended max ∆T of 20 ºC
where θcc is the thermal resistance from core to case and θca from case to
ambient. To calculate maximum ripple capability with the THAS attached to
a heatsink use the maximum core temperature and the values for θcc.
Example As an illustration, suppose you operate an noninsulated
THAS112M060AA0C in 85 ºC air and attach it to a commercial heatsink
with a free-air thermal resistance of 2.7 ºC/W. Use a good thermal grease
between the capacitor and the heatsink, and the total thermal resistance
is 2.7 + 6.6 or 9.3 º C/W. The power which would heat the core to 105 °C is
(105 - 85)/9.3 or 2.15 W. For an ESR of 117 mΩ, 2 .15 W equates to a ripple
current of 4.28 A.
CDM Cornell Dubilier • 140 Technology Place • Liberty, SC 29657 • Phone: (864)843-2277 • Fax: (864)843-3800
Type THAS,ThinPack, Aluminum Electrolytic Capacitor, 105 ºC
