MAX703/MAX704
Low-Cost Microprocessor Supervisory
Circuits with Battery Backup
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(V
CC
= +4.75V to +5.5V for MAX703, V
CC
= +4.5V to +5.5V for MAX704, V
BATT
= 2.8V, T
A
= T
MIN
to T
MAX
, unless otherwise noted.)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Terminal Voltage (with respect to GND)
V
CC
....................................................................-0.3V to +6.0V
V
BATT
.................................................................-0.3V to +6.0V
All Other Inputs (Note 1).........................-0.3V to (V
CB
+ 0.3V)
Input Current
V
CC
...............................................................................200mA
V
BATT
..............................................................................50mA
GND ................................................................................20mA
Output Current
V
OUT
...............................Short-Circuit Protected for Up to 10s
All Other Outputs ............................................................20mA
Rate-of-Rise V
BATT
, V
CC
.................................................100V/µs
Operating Temperature Range
C Suffix................................................................0°C to +70°C
E Suffix.............................................................-40°C to +85°C
M Suffix ..........................................................-55°C to +125°C
Continuous Power Dissipation (T
A
= +70°C)
8-Pin PDIP (derated 9.09mW/°C above +70°C) ..........727mW
8-Pin SO (derated 5.88mW/°C above +70°C) .............471mW
8-Pin CERDIP (derated 8.00mW/°C above +85°C) .....640mW
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10s) .................................+300°C
Note 1: V
CB
is the greater of V
CC
and V
BATT
. The input voltage limits on PFI and MR may be exceeded if the current into these pins
is limited to less than 10mA.