SPEC NO: DSAN8399 REV NO: V.3A DATE: MAR/24/2015 PAGE: 2 OF 5
APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1203014466
Selection Guide
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
* Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Absolute Maximum Ratings at TA=25°C
Electrical / Optical Characteristics at TA=25°C
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Part No. Dice Lens Type
Iv (mcd) [2]
@ 2mA
iewing
Angle [1]
Min. Typ. 2θ1/2
Hyper Red (AlGaInP) Water Clear
50 100
120
°
*20 *40
APT3216LSECK/J3-PRV
Symbol Parameter Device Typ. Max. Units Test Conditions
λpeak Peak Wavelength Hyper Red 640 nm I
F=2mA
λD [1] Dominant Wavelength Hyper Red 625 nm I
F=2mA
Δλ1/2 Spectral Line Half-width Hyper Red 20 nm I
F=2mA
C Capacitance Hyper Red 27 pF V
F=0V;f=1MHz
V
F [2] Forward Voltage Hyper Red 1.8 2.1 V IF=2mA
I
R Reverse Current Hyper Red 10 uA VR=5V
Min.
1.5
Parameter Hyper Red Units
Power dissipation 63 mW
DC Forward Current 30 mA
Peak Forward Current [1] 150 mA
Reverse Voltage 5 V
Operating Temperature -40°C To +85°C
Storage Temperature -40°C To +85°C
