Surge arrester B88069X9231****
2-electrode arrester S30-A90X
PPD AB PD / PPD AB PM Version: 09 / 2017-05-10
Please read Cautions and warnings and Page 6 of 7
Important notes at the end of this document.
Soldering parameter
Reflow soldering
Reflow profile
features
Sn- Pb eutectic
assembly
Pb-free
assembly
Preheat and soak
- Temperature min
- Temperature max
- Time
T
smin
T
smax
t
smin
to t
smax
100 °C
150 °C
60 ... 120 s
150 °C
200 °C
60 ... 180 s
Average ramp-up
rate
T
smax
to T
p
max. 3 °C/ s max. 3 °C/ s
Liquidous
temperature
Time at liquidous
T
L
t
L
183 °C
60 ... 150 s
217 °C
60 ... 150 s
Peak package body
temperature *,
Classification
temperature **
T
p
, T
C
220 ... 235 °C ** 245 ... 260 °C **
Time (t
p
) ** within
5 °C of the specified
classification
temperature (T
C
)
20 s *** 30 s ***
Average ramp-down
rate
T
p
to T
smax
max. 6 °C/ s max. 6 °C/ s
Time 25 °C to peak
temperature
max. 6 min max. 8 min
* = Tolerance for peak profile temperature (T
p
) is defined as a supplier minimum
and a user maximum.
** = For details please refer to JEDEC J-STD-020D.
*** = Tolerance for time at peak profile temperature (t
p
) is defined as a supplier
minimum and a user maximum.
Surface mounted components (SMD) may exhibit a temporary increase in the DC spark-over voltage after the solder reflow
process. The components will recover within 24 hours. There is no quality defect nor change in protection levels during the
temporary change in DC spark-over voltage.
Cautions and warnings
Do not operate surge arresters in power supply networks, whose maximum operating voltage
exceeds the minimum spark-over voltage of the surge arresters.
Surge arresters may become hot in the event of longer periods of current stress (burn risk). In the
event of overload the connectors may fail or the component may be destroyed.
Surge arresters must be handled with care and must not be dropped.
Do not continue to use damaged surge arresters.
The shown SMD pad dimensions represent a safe way to mount the arrester and are a
recommendation of the manufacturer. During the reflow process it must be assured that no solder
material reduces the insulation distance between the pads below the arrester.
SMD surge arresters should be soldered within 24 month after shipment.
Display of ordering codes for EPCOS products
The ordering code for one and the same EPCOS product can be represented differently in data
sheets, data books, other publications, on the EPCOS website, or in order-related documents such as
shipping notes, order confirmations and product labels. The varying representations of the
ordering codes are due to different processes employed and do not affect the specifications of
the respective products. Detailed information can be found on the Internet under
www.epcos.com/orderingcodes
