IR-1759 MiniRay Infrared Heating Tool
10-18
Application Equipment
Catalog 1654025 Dimensions are shown for Dimensions are in millimeters USA: +1 800 522 6752 For additional support numbers
Revised 3-13 reference purposes only. unless otherwise specified. Asia Pacific: +86 0 400 820 6015 please visit www.te.com
Specifications subject UK: +44 800 267 666
www.te.com to change.
Product Facts
n Small, lightweight,
fan-cooled unit
n Small profile for installation
where space is restricted
n Handheld operation
n Focused heat
n Quiet, efficient IR operation
n CE approved
n RoHS compliant
Applications
Used for installing
SolderSleeve devices and
SolderTacts contacts.
* Control box not shown
Available in: Americas
1
Europe Asia Pacific
nnn
The MiniRay tool is a hand
held Infrared heating tool
designed for installing
shield terminators, splices
and approved IR repair
and tubing products.*
The tool is portable, light-
weight and is convenient
for use where work space is
restricted. The hand tool is
fan cooled and has low heat
emission as the lamp is only
energized on demand. A
duty cycle up to 50% is
permissible with a maximum
heating time of 30 seconds.
Two versions of the hand
tool are available:
n IR-1759-MK4/A
Standard aperture
recommended for prod-
ucts up to 6 mm diame-
ter.
n IR-3104-MK4/A Large
aperture for
products up to 9 mm
diameter.
Both versions of the tool will
accept larger diameter
components but uniform
heating is then not assured.
The battery box controller is
designed for remote areas,
where more portability is
required. This battery-pow-
ered controller can install
approximately 50, 30
second installations before
recharging is required. The
ED-7-001-MK4-230V-50HZ
and ED-7-002-MK4-110V-
60HZ Control units provide
controls for both power and
time and are suitable where
the use of pre-set installa-
tion conditions is required.
Up to 20 memory locations
are available for the storage
of time/power values. A
trigger switch is used to
initiate each cycle. The
controller can also be used
in a manual mode with the
operator controlling the
duration of the heating
cycle via the trigger switch.
The ED-7-CONT-230/110V-
MK4 controller is a more
simpler unit, with no vari-
able time, or variable power
memory functions, and
maintains power to the
lamp for as long as the
trigger switch remains
depressed. The tool can
be used with either 230V
or 110V (nominal) voltage
supply.
The product being installed
is visible during the heating
cycle. An optical filter elimi-
nates the unwanted UV
emissions and excess visi-
ble light reducing the glare
for the operator.
A product kit is available,
see page 10-19 for ordering
information.
*Contact your local TE
representative for details.
1
Approved by the U.S.
Navy for use on fueled
aircraft.