4/7
www.rohm.com
○
c
2012 ROHM Co., Ltd. All rights reserved.
2012.03 - Rev.H
Data Sheet TCFG Series A Case
Temperature
Stability
−
Shall be satisfied the voltage on "Standard list"
Less than 1000% of initial limit
Less than 1250% of initial limit
+125
°C
Apply the specified surge voltage via the serial
resistance of 1kΩ every 5±0.5min.
for 30±5 s. each time in the atmospheric conditio
of 85±2°C.
Repeat this procedure 1,000 times.
After the specimens, leave it at room temperatu
for over 24h and then measure the sample.
Surge
Voltage
There should be no significant abnormality.
The indications should be clear.
Less than initial limit
Within 0/−12%of initial value
−55
°C
+85°C
Shall be satisfied the voltage on "Standard list"
Within +10/0%of initial value
Within +15/0%of initial value
Less than initial limit
Shall be satisfied the voltage on "Standard list"
Loading at
High
temperature
There should be no significant abnormality.
The indications should be clear.
After applying the rated voltage for 2000+72/0
without discontinuation via the serial resistanc
of 3Ω or less at a temperature of 85±2°C, leav
the sample at room temperature/humidity for
over 24h and measure the value.
Within
±
10%of initial value
Less than initial limit
Less than initial limit
Terminal
Strength
The measured value should be stable.
A force is applied to the terminal until it bends
to 1mm and by a prescribed tool maintain the
condition for 5s. (See the figure below.)
Temp.
ΔC / C
L.C
Temp.
ΔC / C
tanδ
L.C
ΔC / C
L.C
Temp.
Appearance
ΔC / C
tanδ
L.C
tanδ
tanδ
Appearance
ΔC / C
L.C
tanδ
Capacitance
Appearance
There should be no significant abnormality.
1
F (Apply force)
(Unit : mm)
20
50
R230
45 45
Thickness 1.6mm
Adhesiveness The terminal should not come off.
Apply force of 5N in the two directions shown
in the figure below for 10
±1s after mounting
the terminal on a circuit board.
Apply force
a circuit board
product
C105
YAA
As per 4.29 JIS C 5101-1
As per 4.13 JIS C 5101-3
As per 4.26 JIS C 5101-1
As per 4.14 JIS C 5101-3
As per 4.23 JIS C 5101-1
As per 4.15 JIS C 5101-3
As per 4.35 JIS C 5101-1
As per 4.9 JIS C 5101-3
As per 4.34 JIS C 5101-1
As per 4.8 JIS C 5101-3
Item Performance
Test conditions
(based on JIS C5101-1 and JIS C5101-3)
Others
: Within
±
10
% of initial value
TCFGA1A226M8R
: Within
±
15
% of initial value
TCFGA0J476M8R
: Within
±
15
% of initial value
TCFGA0G686M8R
: Within
±
15
% of initial value