For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
Application Support: Phone: 978-250-3343 or apps@hittite.com
HIGH SPEED LOGIC - SMT
7
HMC859LC3
v02.0914
26 GHz, DIVIDE-BY-8 WITH RESET &
PROGRAMMABLE OUTPUT VOLTAGE
Evaluation PCB
The circuit board used in the application should use
RF circuit design techniques. Signal lines should
have 50 Ohm impedance while the package gro-
und leads should be connected directly to the
ground plane similar to that shown. The exposed
packaged base should be connected to Vee. A
sufficient number of via holes should be used to
connect the top and bottom ground planes. The
evaluation circuit board shown is available from Hit-
tite upon request. Install jumper on JP1 to short VR
to GND for normal operation.
List of Materials for Evaluation PCB 123585
[1]
Item Description
J1, J2, J5, J6 PCB Mount SMA RF Connectors
J3, J4 PCB Mount 2.92mm RF Connectors
J7 - J9 DC Pin
JP1 2-Position Header with Shunt
C1 - C2 100 pF Capacitor, 0402 Pkg.
C3 - C4 4.7 µF Capacitor, Tantalum
R1 10 Ohm Resistor, 0603 Pkg.
U1 HMC859LC3 Clock Divider
PCB
[2]
118775 Evaluation Board
[1] Reference this number when ordering complete evaluation PCB
[2] Circuit Board Material: Arlon 25FR or Rogers 4350