RoHS Compliant
Serial ATA Flash Drive
SFD25M5 Product Specifications
August 8
th
, 2014
Version 1.1
Apacer Technology Inc.
1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C
Tel: +886-2-2267-8000 Fax: +886-2-2267-2261
www.apacer.com
Serial ATA Flash Drive
APS25MBAxxxx-XTX
1
©2014 Apacer Technology Inc. Rev. 1.1
Features:
Compliance with SATA Revision 3.1
Serial ATA Revision 3.1
SATA 6.0 Gbps interface
Backward compatible with SATA 1.5 and
3.0 Gbps interfaces
ATA-8 command set
Capacities
4, 8, 16, 32, 64 GB
Performance*
Burst read/write: 600 MB/sec
Sustained read: up to 160 MB/sec
Sustained write: up to 155 MB/sec
Flash Management
Built-in hardware ECC, enabling up to 40
bit correction per 1K bytes
Static/dynamic wear leveling
Flash bad-block management
S.M.A.R.T.
Power Failure Management
ATA Secure Erase
TRIM
NAND Flash Type: SLC
Temperature ranges
Operating:
Standard: 0°C to 70°C
Extended: -40°C to 8C
Storage: -4C to 100°C
Supply voltage
5.0 V 5%
Power consumption (typical)*
Active mode: 270 mA
Idle mode: 130 mA
Form factor
Half-size of SATA 2.5”
Dimensions (70.00x48.66x9.25, unit: mm)
Connector
7-pin SATA signal connector
15-pin SATA power connector
Shock & Vibration**
Shock: 1500 G
Vibration: 15 G
SATA Power Management
Device Sleep mode (optional)
RoHS compliant
*Varies from capacities. The values addressed here are typical and may vary depending on settings and platforms.
**Non-operating
Serial ATA Flash Drive
APS25MBAxxxx-XTX
2
©2014 Apacer Technology Inc. Rev. 1.1
Table of Contents
1. Product Description ............................................................................................... 3
1.1
Introduction .................................................................................................................................................3
1.2
Capacity Specification.................................................................................................................................3
1.3
Performance.................................................................................................................................................3
1.4 Pin Assignments ..........................................................................................................................................4
2. Software Interface................................................................................................... 6
2.1
Command Set ..............................................................................................................................................6
2.2
S.M.A.R.T. ...................................................................................................................................................6
3. Flash Management ................................................................................................. 8
3.1
Error Correction/Detection ........................................................................................................................8
3.2 Flash Block Management...........................................................................................................................8
3.3 Wear Leveling .............................................................................................................................................8
3.4
Power Failure Management .......................................................................................................................8
3.5
ATA Secure Erase .......................................................................................................................................8
3.6 TRIM ...........................................................................................................................................................9
3.7 SATA Power Management ........................................................................................................................9
4. Environment Specifications ................................................................................ 10
4.1 Environmental ..........................................................................................................................................10
4.2
Mean Time Between Failures (MTBF)....................................................................................................10
4.3
Certification and Compliance ..................................................................................................................10
5. Electrical Characteristics..................................................................................... 11
5.1
Operating Voltage .....................................................................................................................................11
5.2 Power Consumption .................................................................................................................................11
6. Physical Characteristics ...................................................................................... 12
6.1
Dimensions .................................................................................................................................................12
7. Product Ordering Information ............................................................................. 13
7.1
Product Code Designations ......................................................................................................................13
7.2
Valid Combinations ..................................................................................................................................14

APS25MBA032G-BT

Mfr. #:
Manufacturer:
Apacer
Description:
Solid State Drives - SSD SFD 25M5 SATA FLASH DRIVE SLC 32GB ST
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union