MP2608- 28V, 1A DUAL INPUT LINEAR BATTERY CHARGER WITH TIMER
MP2608 Rev. 0.9 www.MonolithicPower.com 4
8/29/2008 MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2008 MPS. All Rights Reserved.
PIN FUNCTIONS
Pin # Name Description
1 IN Input Supply. IN receives the AC adapter supply voltage.
2 USB Input Supply. USB receives the USB supply voltage.
3
FAULT
Open-Drain Fault Status Indicator. This pin is low under any fault conditions.
4
STATUS
Open-Drain Charge Indicator. This pin is low during charging.
5 SHDN
Charger IC Shut-down. Pull SHDN high to disable the IC or leave it floating to
enable the IC.
6 IBF Programmable Input for end of charger current.
7 TMR
Oscillator Period Timer. Connect a timing capacitor between this pin and GND to
set the oscillator period. A 1uF capacitor on the TMR pin will make the oscillator
period 400ms.
8 GND
Ground. Exposed pad and GND must connect to same ground plane.
9 ICHG
Constant Charge Current Program for the IN input. Connect this pin to an external
resistor to program the charging current in CC Mode when the current from the IN
pin charges the battery.
10 BATT Charger Output.