Part No: CEM-1212C
Description: magnetic buzzer
Phone: 800.275.4899 Fax: 503.372.1266 www.cui.com 20050 SW 112th Ave. Tualatin, OR 97062
Date: 9/08/2006
Unit: mm
Page No: 3 of 5
Environment Test
noitidnoC tseTmetI
rof C°07+ ta rebmahc a ni decalp gnieb retfAtset .pmet hgiH
96 hours.
rof C°03- ta rebmahc a ni decalp gnieb retfAtset .pmet woL
96 hours.
enO .selcyc 01 ot detcejbus eb dluohs trap ehTkcohS lamrehT
cycle will consist of:
Temp./Humidity cycle test The part shall be subjected to 10 cycles. One
cycle will be 24 hours and consist of:
Evaluation Standard
After the test, the part should
meet specifications without any
damage in appearance or
performance. The SPL should be
within ±10 dBA when compared
to the initial measurement.
Mechanical Characteristics
noitidnoC tseTmetI
rof nisor ni desremmi era slanimret daeLytilibaredloS
5 seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
Soldering Heat Resistance Lead terminals are immersed solder bath of
260 ±5°C for 3 ±1 seconds.
Terminal Mechanical Strength For 10 seconds, the force of 9.8N (1.0kg) is
applied to each terminal in axial direction.
gniylppa retfa derusaem eb dluohs rezzub ehTnoitarbiV
a vibration amplitude of 1.5mm with 10 to 55 Hz
band of vibration frequency to each of the 3
perpendicular directions for 2 hours.
fo thgieh a morf deppord eb dluohs trap ehTtseT porD
75 cm onto a 40 mm thick wooden board 3
times in 3 axes (X, Y, Z) for a total of 9 drops.
Evaluation Standard
90% min. of the lead terminals
will be wet with solder.
(Except the edge of the terminal.)
No interference in operation.
No damage or cutting off.
After the test, the part should
meet specifications without any
damage in appearance or
performance. The SPL should be
within ±10 dBA when compared
to the initial measurement.
1
Notes: 1. Not recommended for wave soldering
For more information, please visit the product page.
