AUIR2085S
www.irf.com © 2014 International Rectifier
11
Pin Descriptions
Cs: The input pin to the overcurrent comparator. Exceeding the overcurrent threshold value specified in
“Static Electrical Parameters” Section will terminate output pulses and start a new soft start cycle as soon as
the voltage on the pin reduce below the threshold value.
OSC: The oscillator-programming pin. Only two components are required to program the internal oscillator
frequency: a resistor connected between the V
CC
pin and the OSC pin, and a capacitor connected from the
OSC to COM. The expected oscillator frequency is shown in Figure 1.
The recommended range of timing resistors RT is between 10kΩ and 100kΩ and range of timing capacitor
CT is between 47pF and 470pF. Timing resistors values less than 10kΩ should be avoided. The value of the
timing capacitor determines the amount of dead time between the two output drivers: lower the CT, shorter
the dead time and vice versa. It is not recommended to use a timing capacitor below 47pF, for best
performance keep the timing components physically as close as possible to the AUIR2085S. Separated
ground and V
CC
traces to the timing components are encouraged.
COM: Signal ground and power ground for all functions. Due to high current and high frequency operation, a
low impedance circuit board ground plane is highly recommended.
HO, LO: High side and low side gate drive pins. The high and low side drivers can directly drive the gate of a
power MOSFET. The drivers are capable of 1A peak source and sink currents. It is recommended that the
high and low drive pins be very close to the gates of the high side and low side MOSFETs to prevent any
delay and distortion of the drive signals.
V
B
: The high side power input connection. The high side supply is derived from a bootstrap circuit using a
low-leakage Schottky diode and a ceramic capacitor. To prevent noise, the Schottky diode and bypass
capacitor should be very close to the AUIR2085S.
V
S
: The high side power return connection. V
S
should be connected directly to the source terminal of high
side MOSFET with a trace as short as possible.
V
CC
: The IC bias input connection for the device. Although the quiescent V
CC
current is very low, total supply
current will be higher, depending on the gate charge of the MOSFETs connected to the HO and LO pins, and
the programmed oscillator frequency, total V
CC
current is the sum of quiescent V
CC
current and the average
current at HO and LO. Knowing the operating frequency and the MOSFET gate charge (Qg) at selected V
CC
voltage, the average current (including bootstrap function) can be calculated from:
Iave = 2 x Qg X f
OSC
To prevent noise problem, a bypass ceramic capacitor connected to V
CC
and COM should be placed as
close as possible to the AUIR2085S.
AUIR2085S has an under voltage lookout feature for the IC bias supply, V
CC
. The minimum voltage required
on V
CC
to make sure that IC will work within specifications must be higher than 8.5V (10V minimum V
CC
is
recommended to prevent asymmetrical gates signal on HO and LO pins that are expected when V
CC
is
between 7.5V and 8.5V).
