NCN1154
www.onsemi.com
3
OPERATING CONDITIONS
MAXIMUM RATINGS
Symbol Pins Parameter Value Unit
V
CC
V
CC
Positive DC Supply Voltage −0.5 to +6.0 V
V
IS
R, L, D+, D−, Rx, Tx
Analog I/O
−2.5 to V
CC
+ 0.5
V
COM+, COM− −2.5 to +6.0
V
IN
IN1, IN2 Control Input Voltage −0.5 to +6.0 V
I
CC
V
CC
Positive DC Supply Current 50 mA
T
S
Storage Temperature −65 to +150 °C
I
IS_CON
COM+, COM−, R, L, D+, D−, Rx, Tx Analog Signal Continuous Current−Closed Switch $100 mA
I
IS_PK
COM+, COM−, R, L, D+, D−, Rx, Tx Analog Signal Continuous Current 10% Duty Cycle $500 mA
I
IN
IN1, IN2 Control Input Current 1.0 mA
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
NOTE: These devices have limited built−in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage.
RECOMMENDED OPERATING CONDITIONS
Symbol Pins Parameter Min Max Unit
V
CC
V
CC
Positive DC Supply Voltage 2.7 5.0 V
V
IS
D+ to COM+, D− to COM−
Analog Signal Voltage (Note 1)
GND V
CC
V
L to COM+, R to COM− −2.0 V
CC
Tx to COM+, Rx to COM− GND V
CC
V
IN
IN1, IN2 Control Input Voltage GND V
CC
V
T
A
Operating Temperature −40 +85 °C
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond
the Recommended Operating Ranges limits may affect device reliability.
1. In USB mode, any signal supplied to the off−state audio inputs R, L may not swing below ground or above 1.5 V.
DC ELECTRICAL CHARACTERISTICS
CONTROL INPUT Min and Max apply for T
A
between −40°C to +85°C and T
J
up to +125°C (Unless otherwise noted). Typical values
are referenced to T
A
= +25°C, V
CC
= 3.3 V.
Symbol
Pins Parameter Test Conditions V
CC
(V)
−40°C to +85°C
Uni
Min Typ Max
V
IH
IN1, IN2 Control Input HIGH Voltage 2.7
3.3
4.2
1.3
1.4
1.5
− − V
V
IL
IN1, IN2 Control Input LOW Voltage 2.7
3.3
4.2
− − 0.4
0.4
0.4
V
I
IN
IN1, IN2 Current Input Leakage
Current
0 ≤ V
IS
≤ V
CC
− − ±50 nA
