SPEC NO: DSAF1088 REV NO: V.11A DATE: AUG/02/2016 PAGE: 2 OF 5
APPROVED: Wynec CHECKED: Allen Liu DRAWN: L.T.Zhang ERP: 1203012851
Selection Guide
Absolute Maximum Ratings at TA=25°C
Electrical / Optical Characteristics at TA=25°C
Part No. Emitting Color (Material) Lens Type
Iv (mcd) [2]
@ 20mA
iewing
Angle [1]
Min. Typ. 2θ1/2
APD3224SURCK-F01 Hyper Red (AlGaInP) Water Clear
1300 2700
*700 *1500
20
°
Symbol Parameter Emitting Color Typ. Max. Units Test Conditions
λpeak Peak Wavelength Hyper Red 645 nm I
F=20mA
λD [1] Dominant Wavelength Hyper Red 630 nm I
F=20mA
Δλ1/2 Spectral Line Half-width Hyper Red 28 nm I
F=20mA
C Capacitance Hyper Red 35 pF V
F=0V;f=1MHz
V
F [2] Forward Voltage Hyper Red 1.95 2.5 V IF=20mA
I
R Reverse Current Hyper Red 10 uA VR=5V
Parameter Values Units
Power dissipation 75 mW
DC Forward Current 30 mA
Peak Forward Current [1] 185 mA
Reverse Voltage 5 V
Operating Temperature -40°C To +85°C
Storage Temperature -40°C To +85°C
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
* Luminous intensity value is traceable to CIE127-2007 standards.
Notes:
1. Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to CIE127-2007 standards.
4. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static
electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033.
