Z-Power LED X10490Z-Power LED X10490
Technical Data Sheet
Rev. 20Rev. 20
FEBRUARY. 2013FEBRUARY. 2013
www.seoulsemicon.com www.seoulsemicon.com
25
Document No. : SSC-QP-7-07-24 (Rev.00)
3. Reflow Soldering Conditions / Profile
4. Hand Soldering conditions
Lead : Not more than 3 seconds @MAX280
Slug : Use a thermal-adhesives
Pre-heating
YWW
X_W
X\W
¥
W
YYW
Y[W
Y]W
Rising
5 °C/sec
{GaGyGGGGOGZWGUP
{GaGzGGGwjiGOP
{GaGzGGGwjiGOP
{GaGzGGGwjiGOP
Cooling
-5 °C/sec
{
o
* Caution
1. Reflow soldering should not be done more than one time.
2. Repairing should not be done after the LEDs have been soldered.
When repairing is unavoidable, suitable tools have to be used.
3. The bottom of the emiter is to be soldered.
4. When soldering, do not put stress on the LEDs during heating.
5. After soldering, do not warp the circuit board.
6. Recommend to use a convection type reflow machine with 7 ~ 8 zones.
