1SD418F2
Data Sheet 1SD418F2-FZ1200R33KL2C
Page 2 CT-Concept.com
Important Notes
This data sheet contains only product-specific data. For a detailed description, must-
read application notes and common data that apply to the whole series, please refer to
the “Description & Application Manual for 1SD418F2 SCALE High-Voltage IGBT Drivers”.
When applying SCALE plug-and-play drivers, please note that these drivers are
specifically adapted to a particular type of IGBT module. Therefore, the type
designation of SCALE plug-and-play drivers also includes the type designation of the
corresponding IGBT module. These drivers are not valid for IGBT modules other
than those specified. Incorrect use may result in failure.
Mechanical and Electrical Interfaces
Dimensions: 183 x 38 (47) mm. Mounting Principle: Direct screw mount on IGBT.
Interface Remarks Part type #
Drive signal input Fiber-optic receiver (Notes 16,18) HFBR-2522
Status output Fiber-optic transmitter (Notes 16,19) HFBR-1522
Power supply connector On-board connector (Note 17) 77315-101-05
Power supply connector Designator Pin numbers
Ground GND 1, 2, 4, 5
Supply voltage
3
Absolute Maximum Ratings
Parameter Remarks Min Max Units
Supply voltage
VDC to GND (Note 1) 0 16 V
Gate peak current
Note 8 -18 +18 A
Average supply current
Note 3 400 mA
Output power DC/DC converter Notes 3,12 4 W
Switching frequency Note 12 4 kHz
Test voltage (50Hz/1min) Primary to output (Note 15) 6000 V
AC(eff)
DC-link voltage Note 5 2200 V
Operating temperature Note 12 -40 +85 °C
Storage temperature -40 +90 °C