LTC1272
12
1272fc
For more information www.linear.com/1272
APPLICATIONS INFORMATION
Figure 10. Unipolar 0V to 5V Operation with Gain Error Adjust
R3
15Ω
LTC1272 • F10
–
+
A
IN
AGND
R2
20k
R1
200Ω
V
IN
0V TO 5V
ANALOG
INPUT
A1
LT1007
*ADDITIONAL PINS OMITTED FOR CLARITY
LTC1272
1
3
Application Hints
Wire wrap boards are not recommended for high reso-
lution or high speed A/D converters. To obtain the best
performance from the LTC1272 a printed circuit board is
required. Layout for the printed circuit board should en-
sure that digital and analog signal lines are separated as
much as possible. In particular, care should be taken not
to run any digital track alongside an analog signal track
or underneath the LTC1272. The analog input should be
screened by AGND.
A single point analog ground separate from the logic system
ground should be established with an analog ground plane
at pin 3 (AGND) or as close as possible to the LTC1272,
as shown in Figure 11. Pin 12 (LTC1272 DGND) and all
other analog grounds should be connected to this single
analog ground point. No other digital grounds should be
connected to this analog ground point. Low impedance
analog and digital power supply common returns are es-
sential to low noise operation of the ADC and the foil width
for these tracks should be as wide as possible.
Noise: Input signal leads to A
IN
and signal return leads
from AGND (pin 3) should be kept as short as possible to
minimize input noise coupling. In applications where this
is not possible, a shielded cable between source and ADC
is recommended. Also, since any potential difference in
grounds between the signal source and ADC appears as
an error voltage in series with the input signal, attention
should be paid to reducing the ground circuit impedances
as much as possible.
In applications where the LTC1272 data outputs and
control signals are connected to a continuously active
microprocessor bus, it is possible to get LSB errors in
conversion results. These errors are due to feedthrough
from the microprocessor to the successive approximation
comparator. The problem can be eliminated by forcing the
microprocessor into a Wait state during conversion (see
Slow Memory Mode interfacing), or by using three-state
buffers to isolate the LTC1272 data bus.
Timing and Control
Conversion start and data read operations are controlled by
three LTC1272 digital inputs; HBEN, CS and RD. Figure 12
shows the logic structure associated with these inputs.
The three signals are internally gated so that a logic “0” is
required on all three inputs to initiate a conversion. Once
initiated it cannot be restarted until conversion is complete.
Converter status is indicated by the BUSY output, and this
is low while conversion is in progress.
Figure 11. Power Supply Grounding Practice
LTC1272 • F11
A
IN
AGND
V
REF
V
DD
DGND
LTC1272
DIGITAL
SYSTEM
C1
C2
C3 C4
+
–
ANALOG GROUND PLANE
GROUND CONNECTION
TO DIGITAL CIRCUITRY
ANALOG
INPUT
CIRCUITRY
3 2 24 12
1