OVER TEMPERATURE
Tj 170 typically (U1) Detect on main control IC℃
SPECIFICATION
MODEL LPHC-18-350 LPHC-18-700
DC VOLTAGE RANGE
RATED CURRENT
RATED POWER
OUTPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
VOLTAGE RANGE
FREQUENCY RANGE
EFFICIENCY(Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVER VOLTAGE
6~48V 6~25V
350mA 700mA
16.8W 17.5W
300mVp-p 250mVp-p
±5.0%
±1.0%
±3.0%
3600ms, 100ms / 230VAC
47 ~ 63Hz
80%
80%
0.3A/230VAC
0.25mA / 240VAC
20 ~ 90% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.2%/ (0 ~ 50 )
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristic for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. Suitable for indoor use or outdoor use without direct sunlight exposure.
7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
18W Single Output Switching Power Supply
Constant current mode power supply
180-264VAC input only
Fully encapsulated with IP67 level (Note.6)
Protections:Short circuit / Over voltage / Over temperature
Cooling by free air convection
ⅡClass power unit, no FG
Pass LPS
100% full load burn-in test
Suitable for LED related fixture or appliance
(such as LED Decoration or Advertisement devices)
High reliability / Low cost
2 years warranty
LPHC-18 series
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
(Note 5)
PROTECTION
File Name: LPHC-18-SPEC 2018-01-10
SAFETY STANDARDS
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3KVAC
HOLD UP TIME (Typ.) 20ms/230VAC at full load
50.4~ 60V
28.75~ 33.75V
Protection type : Shut off o/p voltage, clamping by zener diode
140*30*22(L*W*H)
COLD START 50A(twidth=190 s measured at 50% Ipeak) at 230VACμ
Protection type : Hiccup mode, recovers automatically after temperature goes down
BIS IS15885, IP67 approved; design refer to UL1310 Class 2,TUV EN60950-1, CAN/CSA C22.2 No. 223-M91EAC TP TC 004,
1200.6K hrs min. MIL-HDBK-217F (25 )℃
0.175Kg; 70pcs/13.3Kgs/0.71CUFT
■ Features :
IP67
LPS
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH℃
180 ~ 264VAC 254 ~ 370VDC
-30~ +70 (Refer to "Derating Curve")℃
±8.0%CURRENT ACCURACY
Compliance to EN55032 (CISPR32) Class A, EN61000-3-2 Class A, EN61000-3-3, EAC TP TC 020
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A, EAC TP TC 020
EMC IMMUNITY
EMC EMISSION
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
13 units (circuit breaker of type B) / 22 units (circuit breaker of type C) at 230VAC
IS 15885(Part 2/Sec13)
R-41027766
THOMAS SAMUEL
THOMAS SAMUEL
