ADG1436 Data Sheet
Rev. B | Page 12 of 16
TERMINOLOGY
I
DD
The positive supply current.
I
SS
The negative supply current.
V
D
, V
S
The analog voltage on Terminal D and Terminal S.
R
ON
The ohmic resistance between Terminal D and Terminal S.
R
FLAT(ON)
Flatness that is defined as the difference between the maximum
and minimum value of on resistance measured over the
specified analog signal range.
I
S
(Off)
The source leakage current with the switch off.
I
D
(Off)
The drain leakage current with the switch off.
I
D
, I
S
(On)
The channel leakage current with the switch on.
V
INL
The maximum input voltage for Logic 0.
V
INH
The minimum input voltage for Logic 1.
I
INL
, I
INH
The input current of the digital input.
C
S
(Off)
The off-switch source capacitance, which is measured with
reference to ground.
C
D
(Off)
The off-switch drain capacitance, which is measured with
reference to ground.
C
D
, C
S
(On)
The on-switch capacitance, which is measured with reference
to ground.
C
IN
The digital input capacitance.
t
TRANSITION
The delay time between the 50% and 90% points of the digital
input and switch on condition when switching from one
address state to another.
Charge Injection
A measure of the glitch impulse transferred from the digital
input to the analog output during switching.
Off Isolation
A measure of unwanted signal coupling through an off switch.
Crosstalk
A measure of unwanted signal that is coupled through from one
channel to another as a result of parasitic capacitance.
Bandwidth
The frequency at which the output is attenuated by 3 dB.
On Response
The frequency response of the on switch.
Insertion Loss
The loss due to the on resistance of the switch.
THD + N
The ratio of the harmonic amplitude plus noise of the signal to
the fundamental.
