DJ (ADJ)
–4–
ASCTB176E 201612-T
RATING
1. Coil data
1) Single side stable
2) 1 coil latching
3) 2 coil latching
2. Specifications
Notes: *1. This value can change due to the switching frequency, environmental conditions, and desired reliability level, therefore it is recommended to check this with the
actual load.
*2. Wave is standard shock voltage of ±1.2×50μs according to JEC-212-1981
*3. In order to obtain the full rated life cycles, the relay should be properly vented by removing the vent nib. More detail, please look at caution for NOTES.
*4. The upper limit of the ambient temperature is the maximum temperature that can satisfy the coil temperature rise value. Refer to Usage, transport and storage
conditions in NOTES.
3. Electrical life
Condition: Resistive load, at 20 times/min.
Nominal coil voltage
Pick-up voltage
(at 20°C 68°F)
Drop-out voltage
(at 20°C 68°F)
Coil resistance
[±10%] (at 20°C 68°F)
Nominal operating power
Max. applied voltage
(at 20°C 68°F)
5V DC
75%V or less of nominal
voltage (Initial)
10%V or more of nominal
voltage (Initial)
100Ω
250mW 130%V of nominal voltage
6V DC 144Ω
12V DC 576Ω
24V DC 2,304Ω
48V DC 9,216Ω
Nominal coil voltage
Set voltage
(at 20°C 68°F)
Reset voltage
(at 20°C 68°F)
Coil resistance
[±10%] (at 20°C 68°F)
Nominal operating power
Max. applied voltage
(at 20°C 68°F)
5V DC
70%V or less of nominal
voltage (Initial)
70%V or less of nominal
voltage (Initial)
167Ω
150mW 130%V of nominal voltage
6V DC
240Ω
12V DC 960Ω
24V DC 3,840Ω
48V DC 15,360Ω
Nominal coil voltage
Set voltage
(at 20°C 68°F)
Reset voltage
(at 20°C 68°F)
Coil resistance
[±10%] (at 20°C 68°F)
Nominal operating power
Max. applied voltage
(at 20°C 68°F)
5V DC
70%V or less of nominal
voltage (Initial)
70%V or less of nominal
voltage (Initial)
100Ω
250mW 130%V of nominal voltage
6V DC 144Ω
12V DC 576Ω
24V DC 2,304Ω
48V DC 9,216Ω
Characteristics Item Specifications
Contact
Arrangement 1 Form C, 1 Form A, 1 Form B, 1 Form A 1 Form B, 2 Form C, 2 Form A, 2 Form B
Contact resistance (Initial) Max. 100 mΩ (By voltage drop 6 V DC 1A)
Contact material
AgSnO
2 type (1 Form C, 1 Form A, 1 Form B),
Au-flashed AgSnO
2 type (1 Form A 1 Form B, 2 Form C, 2 Form A, 2 Form B)
Rating
Nominal switching capacity (resistive load)
16 A 250V AC (1 Form C, 1 Form A, 1 Form B),
10 A 250V AC (2 Form C, 2 Form A, 2 Form B, 1 Form A 1 Form B)
Max. switching power (resistive load)
4,000 V A (1 Form C, 1 Form A, 1 Form B),
2,500 V A (2 Form C, 2 Form A, 2 Form B, 1 Form A 1 Form B)
Max. switching voltage 250V AC
Max. switching current
16 A (1 Form C, 1 Form A, 1 Form B),
10 A (1 Form A 1 Form B, 2 Form C, 2 Form A, 2 Form B)
Min. switching capacity (Reference value)*
1
100mA 5 V DC
Electrical
characteristics
Insulation resistance (Initial) Min. 1,000MΩ (at 500V DC) Measurement at same location as “Breakdown voltage” section.
Breakdown
voltage (Initial)
Between open contacts 1,000 Vrms for 1min. (Detection current: 10mA)
Between contact and coil 4,000 Vrms for 1min. (Detection current: 10mA)
Between contact sets
2,000 Vrms for 1min. (Detection current: 10mA)
(Only 2 Form C, 2 Form A, 2 Form B, 1 Form A 1 Form B)
Surge breakdown
voltage*
2
(Initial)
Between contact and coil Min. 10,000 V
Operate time [Set time] (at 20°C 68°F) (Initial) Max. 20 ms [20 ms] (Nominal voltage applied to the coil, excluding contact bounce time.)
Release time [Reset time] (at 20°C 68°F)
(Initial)
Max. 20 ms [20 ms] (Nominal voltage applied to the coil, excluding contact bounce time, without diode.)
Mechanical
characteristics
Shock
resistance
Functional Min. 200 m/s
2
(Half-wave pulse of sine wave: 11 ms; detection time: 10μs.)
Destructive Min. 1,000 m/s
2
(Half-wave pulse of sine wave: 6 ms.)
Vibration
resistance
Functional 10 to 55 Hz at double amplitude of 2 mm (Detection time: 10μs.)
Destructive 10 to 55 Hz at double amplitude of 3 mm
Expected life Mechanical Min. 5×10
6
(at 180 times/min.)
Conditions
Conditions for operation, transport and
storage*
4
Ambient temperature: –40°C to +70°C –40°F to +158°F
Humidity: 5 to 85% R.H. (Not freezing and condensing at low temperature)
Unit weight Approx. 14 g .49 oz
Type Switching capacity No. of operations
1 Form A, 1 Form B, 1 Form C 16A 250V AC min. 1×10
5
2 Form A, 2 Form B, 2 Form C,
1 Form A 1 Form B
10A 250V AC min. 1×10
5
