MC74HC08A
http://onsemi.com
2
MAXIMUM RATINGS
Symbol Parameter Value Unit
V
CC
DC Supply Voltage (Referenced to GND) – 0.5 to + 7.0 V
V
in
DC Input Voltage (Referenced to GND) – 0.5 to V
CC
+ 0.5 V
V
out
DC Output Voltage (Referenced to GND) – 0.5 to V
CC
+ 0.5 V
I
in
DC Input Current, per Pin ± 20 mA
I
out
DC Output Current, per Pin ± 25 mA
I
CC
DC Supply Current, V
CC
and GND Pins ± 50 mA
P
D
Power Dissipation in Still Air, SOIC Package†
TSSOP Package†
500
450
mW
T
stg
Storage Temperature – 65 to + 150
_C
T
L
Lead Temperature, 1 mm from Case for 10 Seconds
SOIC or TSSOP Package
260
_C
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress
ratings only. Functional operation above the Recommended Operating Conditions is not implied.
Extended exposure to stresses above the Recommended Operating Conditions may affect device
reliability.
†Derating — SOIC Package: – 7 mW/_C from 65_ to 125_C
TSSOP Package: − 6.1 mW/_C from 65_ to 125_C
RECOMMENDED OPERATING CONDITIONS
Symbol Parameter Min Max Unit
V
CC
DC Supply Voltage (Referenced to GND) 2.0 6.0 V
V
in
, V
out
DC Input Voltage, Output Voltage
(Referenced to GND)
0 V
CC
V
T
A
Operating Temperature, All Package Types – 55 + 125
_C
t
r
, t
f
Input Rise and Fall Time V
CC
= 2.0 V
(Figure 1) V
CC
= 4.5 V
V
CC
= 6.0 V
0
0
0
1000
500
400
ns
ORDERING INFORMATION
Device Package Shipping
†
MC74HC08ADG SOIC−14
(Pb−Free)
55 Units / Rail
MC74HC08ADR2G SOIC−14
(Pb−Free)
2500 / Tape & Reel
MC74HC08ADTR2G TSSOP−14
(Pb−Free)
2500 / Tape & Reel
NLV74HC08ADG* SOIC−14
(Pb−Free)
55 Units / Rail
NLV74HC08ADR2G* SOIC−14
(Pb−Free)
2500 / Tape & Reel
NLV74HC08ADTR2G* TSSOP−14
(Pb−Free)
2500 / Tape & Reel
†For information on tape and reel specifications, including part orientation and tape sizes, please refer to our Tape and Reel Packaging
Specifications Brochure, BRD8011/D.
*NLV Prefix for Automotive and Other Applications Requiring Unique Site and Control Change Requirements; AEC−Q100 Qualified and PPAP
Capable
This device contains protection
circuitry to guard against damage
due to high static voltages or electric
fields. However, precautions must
be taken to avoid applications of any
voltage higher than maximum rated
voltages to this high−impedance cir-
cuit. For proper operation, V
in
and
V
out
should be constrained to the
range GND v (V
in
or V
out
) v V
CC
.
Unused inputs must always be
tied to an appropriate logic voltage
level (e.g., either GND or V
CC
).
Unused outputs must be left open.