No. MATERIAL NAME
MATERIAL REMARKS
PRODUCT NAME or MODEL,TITLE
DC-DC CONVERTER UNIT CC25-xxxxxF-E Series
PAGENAME OF DRAWING DRAWING No.
PRODUCT SPECIFICATIONS TRSA-0292-3 /
TDK CORPORATION
QU
13
2
Please be sure to read these instructions for safe design when using the product.
Improper use may pose the danger of smoke or fire.
Storage
Store the converter unit in the manner specified in the purchase specifications or catalog.
Do not store the converter unit in a corrosive gas or corrosive dust environment.
Do not store the converter unit in a strong electrical or magnetic field. It will cause damage.
Environment & Conditions of Use
Do not operate the converter unit in a corrosive gas or corrosive dust environment.
Operate the converter unit in the environment and under the conditions specified in the purchase
specifications or catalog.
Operate the input and output voltage, output current, etc.
within the rated electrical specifications.
This converter has no built-in over voltage protection.
A continuous over current condition may damage the converter.
This DC to DC converter has a built-in input fuse,
over current of any kind will cause the input to open.
Be sure to insulate the metal case bottom from surrounding components and trace pattern.
Do not operate the converter unit in a strong electrical or magnetic field.
If there is the possibility of surge voltages occurring, take surge voltage prevention
countermeasures.
The metal case of this DC to DC converter is insulated from internal components.
However, if high voltage parts contact the metal case, it may damage the internal components.
Do not change or modify the product ,
TDK will not be responsible for any damage due to modification.
Do not remove or disassemble the case.
The converter unit is not designed to be resistant to radiation.
Do not use it in nuclear power controls, medical equipment, etc.
Give due design consideration for safeguarding against personal injury, fire and other accidents.
The converter unit must be wired according to the measurement circuits
given in the purchase specifications or catalog.
Consult TDK concerning any other connection schemes in order to avoid possible damage.
These converter units cannot be connected in parallel (Fig.1).
These converters may be connected in series, to ensure reliable operation,
TDK recommends the connection shown in Figure 2.
The output current must not exceed the rated current of the smaller converter unit.
Consult us when using this product in vehicles or
in an environment where vibration is regularly applied.
