289
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
Assembly
Assembly Instructions-C15 Amphenol
®
Triax Threaded, 7/8-20 and 11/16-24
Step 1 Slide nut, washer and gasket over cable. Cut off outside
jacket (using razor blade or wire strippers) to dimension a.
Make a clean cut, being very careful not to nick braid. Cut
first braid to dimension b.
Step 2 Slide first braid clamp over braid up to jacket of cable. Fold
first braid back over clamp, making sure braid is evenly dis-
tributed over the surface of the clamp. Trim second jacket to
dimension c, again being very careful not to nick braid.
Step 3 Trim second braid to dimension d. Slide on outer ground
washer insulator and second braid clamp. Fold second braid
back over braid clamp, again making sure that braid is evenly
distributed over surface of clamp.
Step 4 Trim cable dielectric to dimension e.
Step 5 Tin the inside hole of the contact. Tin wire and insert into
contact and solder. Remove any excess solder. Be sure
cable dielectric is not heated excessively and swollen so as
to prevent dielectric from entering body of fitting.
Step 6 Plug only: Place front insulator and outer contact assembly
into back of connector body and push into proper place.
Insert cable-contact assembly into body. Screw nut into body
with wrench until moderately tight.
Stripping dims. ±1/64 inches
(0.4 millimeters)
Plugs 58A, 59 Type 8, 11 Type
a 7/8 (22.2) 15/16 (23.8)
b 19/32 (15.1) 19/32 (15.1)
c 9/16 (14.3) 15/32 (11.9)
d 11/32 (8.7) 5/16 (7.9)
e 11/32 (8.7)∆ 5/16 (7.9)
f 9/64 (3.6) 1/8 (3.2)
Jacks 58A, 59 Type 8 Type
a 19/32 (15.1) 29/32 (23.0)
b 21/64 (8.3) 19/32 (15.1)
c 19/64 (7.5) 9/16 (14.5)
d 1/4 (6.4) 5/16 (7.9)
e 1/4 (6.4)
■
5/16 (7.9)
f 3/32 (2.4) 1/8 (3.2)
■
for 34400 and 34375 Jacks this dimension is .130 (3.3)
D
for 53100 and 53150 Plugs this dimension is .187 (4.5)
53250
53175
53250-1000
53150
53100
52975
34400
