SparkFun Breadboard Power Supply Stick -
3.3V/1.8V
PRT-13157 ROHS
images are CC BY-NC-SA 3.0
Description: T
his is a very simple board that takes a 4-9V input voltage and outputs
a selectable 1.8V or 3.3V regulated voltage. All headers are 0.1" pitch for simple
insertion into a breadboard.
Input power can be supplied to either the DC barrel jack or the two pin header labeled
+ and -. Output power is supplied to the pins labeled GND and VCC. Board has both
an On/Off switch and a voltage select switch (3.3V/1.8V).
The two sets of four GND and VCC pins are spaced such that when connected to our
Basic Breadboard both power busses will be powered.
Note: Headers are not supplied. You will need to supply your own headers to connect
this board to a breadboard. Check below for some breakaway header strips.
Dimensions: 2.15x0.65"
Features:
• 4-9V input voltage via barrel jack or 2-pin header
• 3.3V or 1.8V regulated output voltage
• 800mA Operating Current
• ON/OFF switch
• Output voltage select switch
• Power status LED
• PTC fuse protected power
• 5.5x2.1mm center positive barrel jack
Page 1 of 1
4
16
201
htt
s://www.s
arkfun.com/
roducts/1315
