CS5510/11/12/13
8 DS337F4
SWITCHING CHARACTERISTICS - CS5511/13
(T
A
= 25° C; V+ = 5 V ±5%; V- = 0 V; Input Levels: Logic 0 = 0 V, Logic 1 = V+; C
L
= 50 pF)
Notes: 23. The internal oscillator in the CS5511/13 provides the master clock for performing conversions. Data is
retrieved from the serial port using the SCLK input pin.
24. The minimum SCLK rate for the CS5511/13 assumes that SCLK is logic 0 when idle. When data is being
read from the ADC, SCLK must be burst at a minimum rate of 10 kHz and with a minimum of a 10
percent duty cycle. Rates slower than this can potentially put the ADC into sleep as the sleep mode is
entered after SCLK is logic 1 for t
SLP
time.
25. On the CS5511/13, the serial clock (SCLK) is used to transfer data from the CS5511/13. If SCLK is held
high (logic 1) for t
SLP
or longer, the CS5511/13 enters sleep mode. To exit from sleep mode, SCLK must
be held low (logic 0) for t
WAKE
or longer.
26. Specified using 10% and 90% points on waveform of interest. Output loaded with 50 pF.
Parameter Symbol Min Typ Max Unit
Internal Oscillator Timing
Internal Oscillator Frequency (Note 23) f
osc
32 64 100 kHz
Internal Oscillator Drift Over Temperature - - -0.02 - %/°C
Serial Port Timing
Serial Clock Frequency (Note 24) SCLK - - 2 MHz
SCLK High to Enter Sleep (Notes 24 and 25) t
SLP
200 - 2000 µs
SCLK Low to Exit Sleep (Notes 24 and 25) t
WAKE
10 - - µs
Rise Times (Note 26)
CSB
SCLK
SDO
t
rise
-
-
-
-
-
50
1.0
10
-
µs
µs
ns
Fall Times (Note 26)
CSB
SCLK
SDO
t
fall
-
-
-
-
-
50
1.0
10
-
µs
µs
ns
Serial Clock Pulse Width High
Pulse Width Low
t
6
t
7
200
200
-
-
-
-
ns
ns
SDO Read Timing
CS to Data Valid
t
8
--150ns
SCLK Falling to New Data Bit t
9
--150ns
CS Rising to SDO Hi-Z
t
10
--150ns
CS Falling to SCLK Rising
t
11
200 - - ns
