https://www.phoenixcontact.com/pi/products/1411590
04/28/2017Page2/4
Flush-type connector-SACC-DSI-M12FS-17P-M16XL/0,5-1411590
Technical data
General
a protective cap > IP54. Influences arising from litz wires, cables or PCB
assembly must also be taken into consideration.
Rated current at 40°C 1.5 A
Rated voltage 30 V
Rated surge voltage 0.8 kV
Number of positions 17
Insulation resistance ≥ 100 MΩ
Coding A - standard
Standards/regulations M12 connector IEC61076-2-101
Signal type/category Universal
Status display No
Overvoltage category II
Degree of pollution 3
Connection method Individual wires
Insertion/withdrawal cycles > 100
Torque 0.8 Nm ... 1.3 Nm (Installation-side)
Mounting type Rear mounting M16 x 1.5 With flat nut
Assembly instructions Tightening limitation
Material
Flammability rating according to UL 94 V0
Contact material CuZn
Contact surface material Au
Contact carrier material PA 66
Material, knurls Zinc die-cast, nickel-plated
Sealing material FKM
Cable
Cable type TPE litz wire
Conductor cross section 0.14 mm²
AWG signal line 26
Conductor structure signal line 7x 0.16 mm
Core diameter including insulation 1.1 mm ±0.05 mm
Thickness, insulation 0.21 mm (Core insulation)
Wire colors
brown, blue, white, green, pink, yellow, black, gray, red, violet, gray/pink,
red/blue, white/green, brown/green, white/yellow, yellow/brown, white/
gray
Material conductor insulation TPE
Conductor material Tin-plated Cu litz wires
Standards/specifications M12 connector IEC61076-2-101
Insulation resistance ≥ 20 MΩ*km
Conductor resistance ≤ 57.6 mΩ/m
Nominal voltage, cable 300 V