The Length Sensor Hinge Clamp Assembly provides an easy method
for attachment and mounting of Model LSC and LSQ Length Sensors and
LSCB1 Conversion Bracket. The removable top on the solid zinc LSAHC
mounting block allows quick installation of the Length Sensor handle tube
and provides secure clamping retention. The mounting block pivots freely
in zinc right angle brackets to allow mounting the assembly via clearance
holes for 1/4" dia. bolts.
The lock washers must be used as indicated (between the bolt head and
the top clamp piece). Assemble the top clamp piece as follows.
1. Tighten both bolts so that the top clamp half draws down evenly on
the sensor tube.
2. Tighten the bolts until both lock washers are flat.
3. Then turn each bolt an additional ½ to
¾ turn.
ORDERING INFORMATION
FRONT
VIEW
TOP
VIEW
DIMENSIONS In inches (mm)
CAUTION: Downward tension
on signal cable can cause
wheel(s) to lift. Make sure
cable is clamped to
machine frame near
encoder and allow slack.
NOTE: The weight at the
Length Sensor unit
provides sufficient traction
for accurate operation
when mounted as shown,
with arm angle from
horizontal not exceeding
±30
o
, and with hinge clamp
toward the far extreme of
the extension arm.
Length Sensors should be mounted so measuring
wheel(s) contact ribbon, strip or web as it passes over
a roller. As an alternative, wheel(s) can be driven by
roller surface next to material being measured.
MODEL NO. DESCRIPTION PART NUMBER
LSAHC LSAHC001
Length Sensor Hinge Clamp Assembly
for Model LSC, LSQ, and LSCB1
Lock washers (2) must be
installed between bolt heads
and top clamp piece.
E-clip retaining ring (2)
must be installed in slots.
MODEL LSAHC - LENGTH SENSOR HINGE CLAMP ASSEMBLY
Red Lion Controls
20 Willow Springs Circle
York PA 17402
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
Red Lion Controls Asia
31, Kaki Bukit Road 3 #06-04/05 TechLink
Singapore 417818
Tel +65 6744-6613
Fax +65 6743-3360
Red Lion Controls BV
Basicweg 11b
NL - 3821 BR Amersfoort
Tel +31 (0) 334 723 225
Fax +31 (0) 334 893 793
