Datasheet
www.rohm.com TSZ02201-0RAR1G200060-1-2
© 2012 ROHM Co., Ltd. All rights reserved.
3/18
9.NOV.2012 Rev.001
TSZ22111･15･00
BA14741xx
●Absolute Maximum Ratings (Ta=25℃)
○BA14741
Parameter Symbol Ratings Unit
Supply Voltage VCC-VEE +36 V
Power dissipation Pd
SOP14
450
*1*3
mW
SOP-J14
820
*2*3
mW
Differential Input Voltage
*4
Vid VCC - VEE V
Input Common-mode Voltage Range Vicm VEE - VCC V
Operating Supply Voltage Vopr 4 to 36 (±2 to ±18) V
Operating Temperature Topr -40 to +85 ℃
Storage Temperature Tstg -55 to +125 ℃
Maximum Junction Temperature Tjmax +125 ℃
Output Short Time
*5
Ts
unlimited
(only 1CH short)
Sec
Note: Absolute maximum rating item indicates the condition which must not be exceeded.
Application of voltage in excess of absolute maximum rating or use out absolute maximum rated
temperature environment may cause deterioration of characteristics.
*1 To use at temperature above Ta＝25℃ reduce 4.5mW/℃
*2 To use at temperature above Ta＝25℃ reduce 8.2mW/℃
*3 Mounted on a FR4 glass epoxy PCB(70mm×70mm×1.6mm).
*4 The voltage difference between inverting input and non-inverting input is the differential input voltage.
Then input terminal voltage is set to more than VEE.
*5 To short Output to VCC or VEE, Limited within Pd.
●Electrical Characteristics
○BA14741 (Unless otherwise specified VCC=+15V, VEE=-15V, Ta=25℃)
Parameter Symbol
Limits
Unit Condition
Min. Typ. Max.
Input Offset Voltage
*6
Vio - 1.0 5.0 mV RS≦10kΩ
Input Offset Current
*6
Iio - 10 50 nA -
Input Bias Current
*7
Ib - 60 300 nA -
Large Signal Voltage Gain Av 20 100 - V/mV RL≧2kΩ, OUT=±10V
Common-mode Rejection Ratio CMRR 80 100 - dB
-
Input Common-mode Voltage Range Vicm ±12 ±13.5 - V
-
Power Supply Rejection Ratio PSRR 80 100 - dB
-
Supply Current ICC - 3.0 7.0 mA RL=∞,All Op-Amps
Maximum Output Voltage VOM ±10 ±12.5 - V RL=2kΩ
Output Source Current Isource 10 20 - mA Vin+=1V, Vin-=0V, OUT=0V
Output Sink Current Isink 5 10 - mA Vin+=0V, Vin-=1V, OUT=0V
Slew Rate
SR - 1.0 - V/μs Av=1, RL=2kΩ
Gain Bandwidth Product GBW - 2.2 - MHz f=100kHz
Unity Gain Frequency f
T
- 2.2 - MHz 0dB cross frequency
Input Referred Noise Voltage Vn
- 2.0 4.0 μVrms
RIAA, RS=2.2kΩ, 10Hz to
30kHz
- 10 -
HznV/
RIAA,
S=2.2kΩ,
f=1kHz
Total Harmonic Distortion + Noise THD+N - 0.003 - %
Av=20dB,RL=2kΩ,OUT=1Vrms
f=1kHz,DIN-AUDIO
Channel Separation CS - 100 - dB f=1kHz, input referred
*6 Absolute value.
*7 Current direction: Since first input stage is composed with PNP transistor, input bias current flows out of IC.
