M675S02 Datasheet Rev 1.0 Revised 07Feb2012
Integrated Device Technology, Inc. ● N e t c o m T i m i n g ● www.idt.com ● tel (774) 348-1600
M675S02
SIGE SINGLE FREQUENCY VCSO
Preliminary Datasheet
GENERAL DESCRIPTION
The M675S02 is a single frequency/single output
SAW-based VCSO for low-jitter clock generation. The
SAW (surface acoustic wave) delay line serves as a
high-Q resontaor and the low noise SiGe VCSO IC
provides a low noise floor and low 1/f phase noise. The
combination of the SAW delay line and the custom IC
result in very low phase noise and jitter performance.
The M675S02 is available in frequencies from 500 to
1000 MHz with a guaranteed minimum pull-range
of ±120 ppm. Industry-standard Kvco (VCO Gain)
provides full replacement compatibility for most
designs. The M675S02 is well suited for phase-locked
loop applications, clock and data recovery circuits and
other timing applications in telecom and optical fiber
networking systems.
FEATURES
◆ Integrated SAW device
◆ Low phase jitter 0.2ps rms typical for the M675S02
(50kHz to 80MHz) - Design Target
◆ Output frequencies from 500 to 1000 MHz
(Specify center frequencies at time of order)
◆ Industry-standard Kvco for full compatibility
◆ Differential 3.3V LVPECL output
◆ Single 3.3V power supply
◆ Small 5 x 7.5mm SMT (surface mount) package
◆ Pb-free / Compliant to EC RoHS Directive (RoHS 5/6)
PIN ASSIGNMENT (5 x 7.5mm SMT)
Figure 1: Pin Assignment
BLOCK DIAGRAM
Figure 2: Block Diagram
Sample of Available Output Frequencies
VCSO Center
Frequencies
1
(MHz)
Note 1: Specify VCSO center frequency at time of order
Applications
622.0800 SONET/SDH
625.0000 Gigabit Ethernet
644.5313 GbE FEC
669.3266
SONET/SDH FEC
Table 1: Sample of Available Output Frequencies
M675S02
(Top View)
1
2
34
5
6
VIN
CLK_EN
VCC
nFOUT
GND FOUT
CLK_EN
VIN
FOUT
nFOUT
SAW Delay Line
Phase
Shifter
M675S02
M675S02 SiGe Single Frequency VCSO