Type 4X Polyester Junction Box
PJ Series
Continuous Hinge Door with Twist/Snap Latches
Application
Designed for use as instrument enclosures, electric, hydraulic or
pneumatic control housings, electrical junction boxes or terminal wiring
enclosures.
Provides outstanding insulation and protection where equipment may be
hosed down or be very wet.
Ideal in applications with high temperatures or highly corrosive
environments.
Standards
UL 508 Type 1, 2, 3, 4, 4X, 12, & 13
CSA Type 1, 2, 3, 4, 4X, 12, & 13
Complies with
NEMA Type 1, 2, 3, 4, 4X,12, & 13
IEC 60529, IP66
Construction
Molded fiberglass polyester enclosure with matching cover is easily
punched, cut, or drilled.
Enhanced UV inhibitors protect against outdoor weathering.
10-32 threaded brass inserts are provided for optional inner panel or
terminal kit mounting. Mounting hardware is included.
Stainless steel butterfly type "twist latch" door fasteners.
Stainless steel draw type "snap latch" door fasteners.
Door fasteners include a provision for padlocking.
Twist latch enclosures are available with bonded polycarbonate viewing
windows.
Door is supported with a continuous stainless steel hinge.
Captive oil resistant gasket provides a positive seal.
Threaded brass inserts are provided for mounting feet to the rear of the
enclosure.
Stainless steel mounting brackets and hardware are provided for mounting
to the rear of the enclosure.
Operating temperatures between 130°C and -40°C (266°F to -40°F).
Impact index of 6.78J (5 ft/lb).
For corrosion resistance information, please refer to table in the Technical
Information section.
Finish
Fiberglass polyester material has a gray finish.
Optional inner panels are available in white powder coated finished steel,
unfinished aluminum, or Fiberglass.
Quality Products. Service Excellence.