SST12CP21
DS70005165A-page 4 Preliminary 2014 Microchip Technology Inc.
3.0 PIN ASSIGNMENTS
FIGURE 3-1: PIN ASSIGNMENTS FOR 16-CONTACT UQFN
4.0 PIN DESCRIPTIONS
56 8
16
NC
15 14
NC
VCC1
9
11
12
10
13
VCC2
NC
NC
DET
NC
NC
RFOUT/VCC3
RFOUT/VCC3
NC
2
1
4
3
RFIN
VREF
NC
VCCb
7
70005165 P1.0
Top View
(contacts facing down)
RF and DC GND
0
TABLE 4-1: PIN DESCRIPTION
Symbol Pin No. Pin Name Type
1
1. I=Input, O=Output
Function
GND 0 Ground The center pad should be connected to RF ground
RFIN 1 RF
IN
I RF input, DC decoupled
VREF 2 V
REF
PWR PA enable and idle-current control
NC 3 No Connection No Internal Connection
VCCb 4 Power Supply PWR Supply voltage for bias circuit
NC 5 No Connection No Internal Connection
NC 6 No Connection No Internal Connection
VDET 7 V
DET
O On-chip power detector
NC 8 No Connection No Internal Connection
NC 9 No Connection No Internal Connection
RFOUT 10 RF
OUT
O RF output
RFOUT 11 RF
OUT
O RF output
NC 12 No Connection No Internal Connection
VCC2 13 V
CC2
PWR PWR power supply, 2
nd
stage
NC 14 NC No Internal Connection
VCC1 15 V
CC1‘
PWR PWR power supply, 1
st
stage
NC 16 No Connection No Internal Connection
2014 Microchip Technology Inc. Preliminary DS70005165A-page 5
SST12CP21
5.0 ELECTRICAL SPECIFICATIONS
The DC and RF specifications for the power amplifier
are specified below. Refer to Table 5-2 for the DC volt-
age and current specifications.
Absolute Maximum Stress Ratings (Applied conditions greater than those listed under “Absolute Maxi-
mum Stress Ratings” may cause permanent damage to the device. This is a stress rating only and func-
tional operation of the device at these conditions or conditions greater than those defined in the operational
sections of this data sheet is not implied. Exposure to absolute maximum stress rating conditions may
affect device reliability.)
Input power to pin 1 (P
IN
)
1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +12 dBm
1. Maximum input power for V
CC
= 5V with 50% duty cycle, 802.11g 54 Mbps, with maximum output VSWR = 10:1. At V
CC
=5V,
a10Ω resistor must be included on V
CC1
, as shown in Figures 6-8 and 6-9.
Supply voltage at pins 4, 10, 11, 13 and 15 (V
CC
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +6 V
Reference voltage to pin 2 (V
REF1
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +3.2 V
DC supply current (I
CC
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 600 mA
Operating Temperature (T
A
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40ºC to +85ºC
Storage Temperature (T
STG
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40ºC to +120ºC
Maximum Junction Temperature (T
J
) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +150ºC
Surface Mount Solder Reflow Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C for 10 seconds
TABLE 5-1: OPERATING RANGE
Range Ambient Temp V
CC
Industrial -20°C to +85°C 5.0V
TABLE 5-2: DC ELECTRICAL CHARACTERISTICS AT 25ºC
Symbol Parameter Min. Typ Max. Unit
V
CC
Supply Voltage 4.0 5.0 5.5 V
I
CC
DC Current
for 802.11g, 28 dBm 440 mA
for 802.11b, 28 dBm 440 mA
I
CQ
Idle Current 275 mA
V
REG
Reference Voltage see Figure 6-8 on page 10 2.9 2.95 3.1 V
I
REG
Reference Current 8mA
SST12CP21
DS70005165A-page 6 Preliminary 2014 Microchip Technology Inc.
TABLE 5-3: AC ELECTRICAL CHARACTERISTICS FOR CONFIGURATION AT V
CC
= 5V,
V
REF
= 2.95V, 25ºC, 50% DUTY CYCLE
Symbol Parameter Min. Typ Max. Unit
F
L-U
Frequency range in 802.11b/g applications 2400 2500 MHz
P
OUT
Output power at 3% EVM with 802.11g OFDM at 54
Mbps
25 dBm
Output power at 2.5% EVM with 802.11n MCS7 HT20 24 dBm
Output power at 1.75% EVM with 256 QAM MCS9 HT40 23 dBm
Output power meeting 802.11g spectral mask, 6 Mbps 28 dBm
Output power meeting 802.11n HT20 spectral mask 26 dBm
Output power meeting MCS9-HT40 spectral mask 26 dBm
Output power meeting 802.11b spectral mask with
11 Mbps CCK
28 dBm
G Power gain for 802.11b/g/n/256 QAM 37 39 dB
G
VAR
Gain variation over band ±0.5 dB
2f Second Harmonic at 29 dBm, 802.11b mask compliance
1
-50 dBm/MHz
3f Third Harmonic at 29 dBm, 802.11b mask compliance
1
-50 dBm/MHz
1. See Figure 6-9

SST12CP21-QUCE

Mfr. #:
Manufacturer:
Description:
RF Amplifier 2.4 GHz RF high-power amplifie
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet