MP1740 –3W HIGH EFFCIENCY MONO CLASS-D AUDIO AMPLIFIER
MP1740 Rev. 1.0 www.MonolithicPower.com 5
1/5/2012 MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2012 MPS. All Rights Reserved
PIN FUNCTIONS
Ball
WLCSP
Name
Input/Ouput
/Power
(I/O/P)
Description
A1 INP I Positive differential input
A2 AGND P Analog Ground
A3 VON O Negative BTL output
B1 AVCC P Analog Power Supply
B2 PVCC P Power Supply
B3 PGND P Power Ground
C1 INN I Negative differential input
C2 EN I Enable Input. (drive high to enable the MP1740)
C3 VOP O Positive BTL output
TYPICAL PERFORMANCE CHARACTERISTICS
TEST SET-UP FOR GRAPHS
+
-
EN
VCC
Cs
40kHz Low
Pass Filter
Measurement
Output
C
I
Load
C
I
+
-
Measurement
Input
0.22uF
Cs
0.22uF
Cs
10uF
MP1740
EN
AVCC
AGND
INP
INN
VON
PGND
PVCC
VOP
R
I
R
I
Notes:
5) C
I
was Shorted for any Common-Mode input voltage measurement
6) A 33µH inductor was placed in series with the load resistor to emulate a small speaker for efficiency measurements.
7) The 40 kHz low-pass filter is required even if the analyzer has a low-pass filter.
8) For PSRR test, Please remove the great 10uF decoupling capacitor and just keep the small decoupling capacitors for recovery switching
currents.