PIC16C63A/65B/73B/74B
DS80164A-page 2 2003 Microchip Technology Inc.
Clarifications/Corrections to the Data
Sheet:
In the Device Data Sheet (DS30605C), the following
clarifications and corrections should be noted.
1. Module: SSP (SPI
TM
Mode)
In Section 10.2 (“SPI Mode”), Figure 10-1 and the
note box immediately beneath it have been
amended to better demonstrate the Peripheral OE
line of the SSP module and describe its relation-
ship to the TRISC<5> bit of PORTC.
Changes are indicated in bold.
FIGURE 10-1: SSP BLOCK DIAGRAM
(SPI MODE)
Read Write
Internal
Data Bus
SSPSR reg
SSPM3:SSPM0
bit0
Shift
Clock
SS
Control
Enable
Edge
Select
Clock Select
TMR2 Output
T
CY
Prescaler
4, 16, 64
2
Edge
Select
2
4
TRISC<3>
2
SMP:CKE
RC4/SDI/SDA
RC5/SDO
RA5/SS
/AN4
RC3/SCK/SCL
SSPBUF reg
Peripheral OE
Note 1: When the SPI module is in Slave mode
with SS
pin control enabled
(SSPCON<3:0> = 0100), the SPI module
will reset if the SS pin is set to VDD.
2: If the SPI is used in Slave mode with
CKE = '1', then SS
pin control must be
enabled.
3: When the SPI is in Slave mode with SS
pin control enabled (SSPCON<3:0> =
0100), the state of the SS
pin can affect
the state read back from the TRISC<5>
bit. The Peripheral OE signal from the
SSP module into PORTC, controls the
state that is read back from the
TRISC<5> bit (see Section 5.3 for infor-
mation on PORTC). If Read-Modify-
Write instructions, such as BSF, are
performed on the TRISC register while
the SS
pin is high, this will cause the
TRISC<5> bit to be set, thus disabling
the SDO output.