47
082416
F92 Series
Resin-Molded Chip, Low Profile J-Lead
TEST
F92 series (Temperature range -55ºC to +125ºC)
Condition
P Case A, B Case
At 40°C, 90 to 95% R.H., 500 hours (No voltage applied)
Damp Heat Capacitance Change ........... Refer to page 46 (*1) Refer to page 46 (*1)
(Steady State) Dissipation Factor ................ 150% or less than the initial specified value Initial specified value or less
Leakage Current .................. Initial specified value or less Initial specified value or less
-55°C / +125°C, 30 minutes each, 5 cycles
Temperature Cycles
Capacitance Change ........... Refer to page 46 (*1) Refer to page 46 (*1)
Dissipation Factor ................ 150% or less than the initial specified value Initial specified value or less
Leakage Current .................. Initial specified value or less Initial specified value or less
10 seconds reflow at 260°C, 5 seconds immersion at 260°C.
Resistance to Capacitance Change ........... Refer to page 46 (*1) Refer to page 46 (*1)
Soldering Heat Dissipation Factor ................ 150% or less than the initial specified value Initial specified value or less
Leakage Current .................. Initial specified value or less Initial specified value or less
After application of surge voltage in series with a 33Ω (For “P” case: 1kΩ) resistor at the rate of 30 seconds ON, 30 seconds
OFF, for 1000 successive test cycles at 85ºC, capacitors shall meet the characteristic requirements in the table above.
Surge Capacitance Change ........... Refer to page 46 (*1) Refer to page 46 (*1)
Dissipation Factor ................ 150% or less than the initial specified value Initial specified value or less
Leakage Current .................. Initial specified value or less Initial specified value or less
After 2000 hours’ application of rated voltage in series with a 3Ω resistor at 85°C, or derated voltage in series with a 3Ω
resistor at 125°C, capacitors shall meet the characteristic requirements in the table above.
Endurance Capacitance Change ........... Refer to page 46 (*1) Refer to page 46 (*1)
Dissipation Factor ................ 150% or less than the initial specified value Initial specified value or less
Leakage Current .................. Initial specified value or less Initial specified value or less
Shear Test
After applying the pressure load of 5N for 10±1 seconds horizontally to the center of capacitor side body
which has no electrode and has been soldered beforehand on a substrate, there shall be found neither
exfoliation nor its sign at the terminal electrode.
Terminal Strength
Keeping a capacitor surface-mounted on a substrate upside down and supporting the substrate at
both of the opposite bottom points 45mm apart from the center of capacitor, the pressure strength is
applied with a specified jig at the center of substrate so that the substrate may bend by 1mm as
illustrated. Then, there shall be found no remarkable abnormality on the capacitor terminals.
QUALIFICATION TABLE
