Table 12: Identity Device (Continued)
See Note 1 for setting definitions
Word Bit(s) Setting Default Value Description
93 Shall be 0000h for SATA devices
15 0b Shall be cleared to zero
14 0b Shall be set to one
13 0b 1 = device detected CBLID-above V
IH
0 = device detected CBLID-below V
IL
Device 1 hardware reset result
Device 0 shall clear these bits to zero
Device 1 shall set these bits as follows:
12 0b Reserved
11 0b 0 = Device 1 did not assert PDIAG-
1 = Device 1 asserted PDIAG-
10–9 These bits indicate how Device 1 determined the device
number:
00 = Reserved
01 = a jumper was used
10 = the CSEL signal was used
11 = some other method was used or the method is un-
known
8 0b Shall be set to one
Device 0 hardware reset result. Device 1 shall clear these
bits to zero.
Device 0 shall set these bits as follows:
7 0b Reserved
6 0b 0 = Device 0 does not respond when Device 1 is selected.
1 = Device 0 responds when Device 1 is selected.
5 0b 0 = Device 0 did not detect the assertion of DASP-
1 = Device 0 detected the assertion of DASP-
4 0b 0 = Device 0 did not detect the assertion of PDIAG-
1 = Device 0 detected the assertion of PDIAG-
3 0b 0 = Device 0 failed diagnostics.
1 = Device 0 passed diagnostics.
2–1 00b These bits indicate how Device 0 determined the device
number:
00 = Reserved
01 = a jumper was used
10 = the CSEL signal was used
11 = some other method was used or the method is un-
known
0 0b Shall be set to one
94 15–8 F 00h Vendor's recommended acoustic management value
7–0 V 00h Current automatic acoustic management value
95 (O)V 0000h Stream Minimum Request Size
C400v 2.5-Inch NAND Flash SSD
Device ID
PDF: 09005aef8455a0c2
realssd_c400v_2_5.pdf - Rev. D 09/11 EN
19
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2011 Micron Technology, Inc. All rights reserved.
