MP8903 – LOW DROPOUT, 150mA LINEAR REGULATOR
MP8903 Rev. 1.11 www.MonolithicPower.com 2
4/30/2015 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2015 MPS. All Rights Reserved.
ORDERING INFORMATION
Part Number Package Top Marking Free Air Temperature (T
A
)
MP8903DG–2.5*
R4
MP8903DG–2.85
R5
MP8903DG–3.3
QFN8 (2x2mm)
R6
MP8903DJ–2.5
R4
MP8903DJ–2.85
R5
MP8903DJ–3.3
TSOT23-5
R6
–40°C to +85°C
* For Tape & Reel, add suffix –Z (e.g. MP8903DG–2.85–Z);
For RoHS Compliant Packaging, add suffix –LF (e.g. MP8903DG–2.85–LF–Z)
PACKAGE REFERENCE
TOP VIEW
GND
EN
IN
IN
1
2
3
4
FB
NC
OUT
OUT
8
7
6
5
TOP VIEW
MARKING
IN
GND
EN
1
2
3
5
4
OUT
FB
QFN8 (2x2mm) TSOT23-5
ABSOLUTE MAXIMUM RATINGS
(1)
IN Supply Voltage .......................–0.3V to +7.0V
FB Voltage .........................–0.3V to V
OUT
+ 0.3V
All Other Pins.................................–0.3V to +6V
Continuous Power Dissipation (T
A
= +25°C)
(2)
TSOT23-5 ................................................ 0.57W
QFN8 (2x2mm) .......................................... 1.6W
Junction Temperature...............................150°C
Lead Temperature ....................................260°C
Storage Temperature ............. –65°C to +150°C
Recommended Operating Conditions
(3)
Input Voltage...................................2.7V to 6.5V
Output Voltage.................................1.25V to 5V
Load Current...........................150mA Maximum
Operating Temperature............. –40°C to +85°C
Maximum Junction Temp. (T
J
) ...............+125°C
Thermal Resistance
(4)
θ
JA
θ
JC
TSOT23-5.............................. 220.... 110.. °C/W
QFN8 (2x2mm)....................... 80 ...... 16... °C/W
Notes:
1) Exceeding these ratings may damage the device.
2) The maximum allowable power dissipation is a function of the
maximum junction temperature T
J
(MAX), the junction-to-
ambient thermal resistance
JA
, and the ambient temperature
T
A
. The maximum allowable continuous power dissipation at
any ambient temperature is calculated by P
D
(MAX)=(T
J
(MAX)-
T
A
)/
JA
. Exceeding the maximum allowable power dissipation
will cause excessive die temperature, and the regulator will go
into thermal shutdown. Internal thermal shutdown circuitry
protects the device from permanent damage.
3) The device is not guaranteed to function outside of its
operating conditions.
4) Measured on JESD51-7 4-layer board.