Narrow-pitch connectors
AXN(5/6)
NOTES
1. Preventing vibration and shock
To prevent the PC board from drop-off
faults and to protect soldered spots from
direct stress, use vibration-proof pads
across boards.
Fix the PC boards in place or install a
stopper so that the gap between the
connectors is less than 0.5 mm and that
their mating is level.
2. Prevention of reverse mating
The socket and header are protected
from reverse mating by a molded resin
key. Excessive mating force may damage
the key, so be sure to match chamfered
corners when mating.
• Floating type
3. Static electricity
This type of socket has the terminals
exposed from the connector walls, and
therefore if they are touched with
anything metal, a short circuit will occur.
Also, if the terminals are touched by
hand, the static electricity may damage
the IC.
4. About floating-type connectors
(1) When two floating-type connectors
are used on header, distance tolerance
between connectors is 0.3mm max.
(2) If rotational error exists between two
connectors, distance tolerance between
the two connectors is as follows:
However, A1 is mated with A2, and B1 is
mated with B2.
(3) Please consult us regarding allowable
installation pitch tolerance between
connectors when using two connectors
that have differing number of terminals.
Parallel
Max. 0.5 mm
gap when mated
Chamfered corner
Mating state
A
a. Horizontal b. Vertical
A
B
B
B1
B2
A1 A2
For other details, please verify with
the product specification sheets.
panasonic-electric-works.net/ac
