ADG1411/ADG1412/ADG1413 Data Sheet
Rev. C | Page 12 of 16
TERMINOLOGY
I
DD
The positive supply current.
I
SS
The negative supply current.
V
D
, V
S
The analog voltage on Terminal D and Terminal S.
R
ON
The ohmic resistance between Terminal D and Terminal S.
R
FLAT(ON)
Flatness is defined as the difference between the maximum and
minimum value of on resistance measured over the specified
analog signal range.
I
S
(Off)
The source leakage current with the switch off.
I
D
(Off)
The drain leakage current with the switch off.
I
D
, I
S
(On)
The channel leakage current with the switch on.
V
INL
The maximum input voltage for Logic 0.
V
INH
The minimum input voltage for Logic 1.
I
INL
, I
INH
The input current of the digital input when high or when low.
C
S
(Off)
The off switch source capacitance, which is measured with
reference to ground.
C
D
(Off)
The off switch drain capacitance, which is measured with
reference to ground.
C
D
, C
S
(On)
The on switch capacitance, which is measured with reference
to ground.
C
IN
The digital input capacitance.
t
ON
The delay between applying the digital control input and the
output switching on. See Figure 30.
t
OFF
The delay between applying the digital control input and the
output switching off.
Charge Injection
A measure of the glitch impulse transferred from the digital
input to the analog output during switching.
Off Isolation
A measure of unwanted signal coupling through an off switch.
Crosstalk
A measure of unwanted signal that is coupled through from one
channel to another as a result of parasitic capacitance.
Bandwidth
The frequency at which the output is attenuated by 3 dB.
On Response
The frequency response of the on switch.
Insertion Loss
The loss due to the on resistance of the switch.
Total Harmonic Distortion + Noise (THD + N)
The ratio of the harmonic amplitude plus noise of the signal to
the fundamental.
AC Power Supply Rejection Ratio (ACPSRR)
A measure of the ability of the device to avoid coupling noise and
spurious signals that appear on the supply voltage pin to the
output of the switch. The dc voltage on the device is modulated
by a sine wave of 0.62 V p-p. The ratio of the amplitude of the
signal on the output to the amplitude of the modulation is the
ACPSRR.
