PDA080X Characteristics
WWW.PHIHONG.COM
Input:
AC Input Voltage Range
90VAC to 304VAC
AC Input Frequency
47~63Hz
Maximum Input Current
≤ 2A
Leakage Current
0.5mA maximum at 230VAC Input
Inrush Current
≤ 20A
OUTPUT:
Power Factor
≥ 0.9 at nominal
Ripple and Noise
<7% (p-p)
Efficiency (Target)
85% at 277VAC
84% at 120VAC
Turn-on Delay Time
0.5s maximum at nominal AC Power ON
Environmental:
Temperature
Operation -40 to +60°C
Non-operation -40 to +85°C
Operating Humidity 10 to 95%
Case Temperature
80°C maximum
Warranty
5 Years
Dimming Function: (W Models)
Dimming Control
0-10VDC
Dimming Output to Load
PWM at 500Hz
Dimming Grounding
Dim(-) and Vout(-) must never be connected together to
ensure proper operation and isolation requirements
EMC
EN55015/CISPR 15, FCC 47 CFR Part 15/18, Class A
Immunity
IEC61000-4-2
IEC61000-4-3
IEC61000-4-4
IEC61000-4-5*
IEC61000-4-6
IEC61000-4-8
IEC61000-4-11
IEC61000-3-2 Class C
*Surge Differential mode: 2.0kV, Common mode: 4.0kV
Ring Wave Surge (ANSI C62.41.2 Cat A)
Differential mode: 4.0kV
Common mode: 6.0kV
Input Over Current Protection
The input power line will be fused with a 3.15A fuse
Short-Circuit Protection
The PSU will withstand a short circuit across the
outputs without damage
Open Circuit Protection
Once the circuit is opened, the output voltage should be
less than 120% at nominal AC input conditions
Dielectric Withstand (Hi-pot) Test
Primary to secondary: 4242VDC for 1 minute, 5mA
Insulation Resistance
Primary to secondary: >5M Ohm 500VDC, 1 Minute
Design Life
50K hours at full power, ambient 50°C and Tcase <rating
Wire Connections
Position Terminal Color Specification
Line Black AWG18 solid wire
Neutral White AWG18 solid wire
Ground Green/Yellow AWG18 solid wire
Vout+ Red AWG18 solid wire
Vout- Blue AWG18 solid wire
Dim+ Violet AWG18 Solid wire
Dim- Grey AWG18 Solid Wire
