LightSensor(SKU:SEN0097)
Editing Light Sensor
Contents
1 Introduction
1.1 Specification
2 Wiring Diagram
3 Sample Code
Introduction
This is a BH1750 light intensity sensor breakout board with a 16 bit AD converter built-in which can
directly output a digital signal, there is no need for complicated calculations. This is a more acurate
and easier to use version of the simple foto resistor which only outputs a voltage that needs to be
calculated in order to obtain meaningful data. With the BH1750 Light Sensor intensity can be directly
measured by the luxmeter, without needing to make calculations. The data which is output by this
sensor is directly output in Lux (Lx). When objects which are lighted in homogeneous get the 1 lx
luminous flux in one square meter ,their light intensity is 1lx. Sometimes to take good advantage of
the illuminant, you can add a reflector to the illuminant.So that there will be more luminous flux in
some directions and it can increase the ilumination of the target surface.
For example:
Night: 0.001--0.02;
moonlightnight:0.02--0.3;
cloudy indoor:5--50;