THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
PRODUCT DATA SHEET
Specifications subject to change without notice.
DATA SHEET #: REV:
DATE:
PAGE
OF
Copyright 2001 Connor-Winfield all rights reserved.
a
CRYSTAL CONTROLLED OSCILLATORS
The Connor-Winfield X502 is a
3.3V Crystal Controlled Oscillator
(XO) with LVDS differential
outputs. The X502 is designed
for use with PLL systems
requiring tight frequency stability
vs. change in temperature and
high frequency output over the
commercial temperature range.
The X502 is designed using a 2x
or 4x PLL multiplication to
achieve the high frequency
output.
1 2
X502 - 622.08M
LVDS
CLOCK
SERIES
CENTER
FREQUENCY
FEATURES
DESCRIPTION
ORDERING INFORMATION
3.3V OPERATION
LOW JITTER <2pS RMS
TOTAL FREQUENCY TOLERANCE:
±20ppm
TEMPERATURE RANGE: 0 to 70°C
DIFFERENTIAL LVDS OUTPUTS
SURFACE MOUNT PACKAGE
TAPE AND REEL PACKAGING
RoHS COMPLIANT / LEAD FREE
3.3V SURFACE MOUNT 5.0 x 7.5mm
LVDS CLOCK OSCILLATOR
X502
DS017
01
04/03/07
ABSOL UTE M AXIMUM RATING S
TABLE 1.0
PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS NOTE
Storage Temperature -55 - 125 °C
Supply Voltage (Vcc) -0.5 - 4.6 Vdc
Input Voltage -0.5 - Vcc+0.5 Vdc
OPERATING SPECIFIC ATIONS
TABLE 2.0
PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE
Center Frequency (Fo) 200 - 800 MHz
Total Frequency Tolerance -20 - 20 ppm 1
Operating Temperature Range 0 - 70 °C
Supply Voltage (Vcc) 3.135 3.3 3.465 Vdc
Supply Current (Icc) - - 100 mA
Jitter (BW=10Hz to 20MHz) - - 10 ps rms
Jitter (BW=12kHz to 80MHz) - - 2 ps rms
SSB Phase Noise at 10Hz offset - -75 - dBc/Hz
SSB Phase Noise at 100Hz offset - -95 - dBc/Hz
SSB Phase Noise at 1KHz offset - -110 - dBc/Hz
SSB Phase Noise at 10KHz offset - -125 - dBc/Hz
SSB Phase Noise at 100KHz offset - -120 - dBc/Hz
INPUT CHARACTERISTICS
TABLE 3.0
PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE
Enable Input Voltage (Low) (Vil) -
-
0.3Vcc Vdc 2
Disable Input Voltage (High) (Vih) 0.7Vcc
-
- Vdc 2
LVDS OUTPUT CHARACTERISTICS
TABLE 4.0
PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE
LOAD - - 100 Ohms 3
Output Differential Voltage (Vod) 250 - 450 mV
Duty Cycle at 50% Level 45 50 55 %
Rise / Fall Time - 0.6 1.0 nS
PACKAG E CHARACTERISTICS
TABLE 5.0
Package Hermetically sealed ceramic package with grounded metal cover.
PROCESS RECOMMENDATIONS
TABLE 6.0
Solder Reflow See solder profile on page 2.
Notes
1.0 Includes initial tolerance, deviation over temperature, supply and load variations, shock, vibration and 10 years
aging.
2.0 When oscillator is disabled both output are in a high impedance state (Tri-State)
3.0 Vod measured with 100 ohm resistor between the true output and the complementary output.
X502 0713
622.08M
